Roland XC and RF

[designtcd]

Hello, I have a Roland XC-540, and the heads are gone on it, it's not worth repairing, so I plan to take another machine that doesn't have a cutter on it, and the Roland xc has a cutter on it, so is it possible for me to print on a Roland RF-640 and on the Roland XC-540 to cut. Sorry I don't know English very well

 

[SignMeUpGraphics]

Yes, that should work fine... if you use VersaWorks the crop marks will be the same so you can print on the RF and cut on the XC.
If you use another RIP, just make sure you use Roland marks during print and cut process.

 

[Anthonyk]

Hello, I have a Roland XC-540, and the heads are gone on it, it's not worth repairing, so I plan to take another machine that doesn't have a cutter on it, and the Roland xc has a cutter on it, so is it possible for me to print on a Roland RF-640 and on the Roland XC-540 to cut. Sorry I don't know English very well

Can you tell me if the heads are gone, can i still run the printer to cut only or will i get an error