• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Router Bit Suggestions

T

Think713

New Member
JBurton said:
Like, how are you cutting these? Just trimming the edges down to exactly 4'x8', or a bunch of 1" circles?
I can't count the sheets of aluminum and acm I get out of one belin bit. Somewhere between 20 and 80 if I had to guess, but I don't have any way to gauge that honestly.
Click to expand...
We usually are just cutting blank rectangle shapes. We are doing 24x36's often. And we bounce around from 3mil and 6mil thickness material. Sometimes we route on .5" PVC
Edit* We also do quite a bit of faces for pylon signs, so acrylic and polycarb... but we typically swap the bit for the acrylic and polycarb.
 
You must log in or register to reply here.
Top