• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Summa D140RL not reading registration marks

S

ScottHar

New Member
Our Summa D140RL has been working fine until I decided to slow down the up/down acceleration via Cutter Control, which I've done in the past with no issues. However, after changing the parameters I found that it wouldn't read the registration marks at all anymore. It would keep circling around in a square pattern. I changed the parameters back to AUTO but it still could not find the marks. I thought it might be something to do with Onyx, but I performed an opos calibration directly on the machine and it did the same thing, it would just move around the square quickly and didn't do any calibrating like it usually does.

I've tried resetting everything, restoring from a backup, cleaning the media sensor , etc and nothing has helped. I've booted Cutter Control into service mode but don't want to muck with any of the settings as I have no clue what they're for.

Hoping someone might be able to shed some light on why this suddenly happened. Is the sensor shot?

Thanks,
Scott
 
S

ScottHar

New Member
I restored from a backup I made months ago. I did reset everything to factory default on the cutter itself, but it still wouldn't read the mark.
 
S

ScottHar

New Member
I did, multiple times, it just quickly went around the weeded white square and that was it. It didn't calibrate like it usually does. This is the first time this has happened and we've had this particular cutter for almost 8 years.
 
You must log in or register to reply here.
Top