-
I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...
Ucjv300 changed from lus200 to lus 175. Help needed
- Thread starter signguy85
- Start date
On subtank 2 I had to swap 25 and 26 around. Strange it didn't toss an error. Subtank 1 (1-4) float sensors are correct placement.
When i start the machine and hold func 1+3 and it loads the service menu, when I hit esc twice to get to the menu where it has #adjust,#adjust(cut), #test, ..etc. it never let's me use that particular menu and rather it boots the printer normally. I dont understand how 1 time I was able to access it and it loaded. Any ideas?
Im at a loss on what the problem is. I wouldn't think the subtank would be bad because the float sensors were in right order but who knows. Its odd that subtank 2 (5-8) didn't display an error for the swapped around sensors.
Any ideas on how to diagnose this? I couldn't find the float test procedure in the manual but I doubt that would benefit since the dang menu won't stay open