• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

When it Rains!!!!!!!!

tooserious

tooserious

New Member
Well I got back the mainboard for my Mimaki JV3 130SPII and the slider.(Nothing wrong with the slider) wish I hadn't moved it. The cable marked SCN1 that goes to MCN7(about 2" wide) on the other end is bad....well the little silver things are coming up or pulling back when i try to install it. This cable looks like a bear to replace to . it's from the slider to the mainboard and in the plastic piece that slides..man wish I could repair it???? How do I change it or fix it??? Thank you
 
artbot

artbot

New Member
there's usually twice as much contact surface as needed to properly seat data. with a very sharp quality pair of scissors, you can trim off the entire bottom of the cable (maybe 1mm) taking with it the flaked up tab of aluminum. ...if that is what you are currently dealing with. i've done it before with data cables.

since this is a bit of a sensitive issue, i'd post pics and have everyone take a look at it. i can't imagine you having more trouble without ending up in the funny farm.
 
tooserious

tooserious

New Member
Oh here it is!!!!!
 

Attachments

  • IMG_20110719_003817.jpg
    IMG_20110719_003817.jpg
    50.6 KB · Views: 68
  • IMG_20110719_003824.jpg
    IMG_20110719_003824.jpg
    44.2 KB · Views: 64
G

genericname

New Member
tooserious said:
Oh here it is!!!!!
Click to expand...

Looks like there may just be a lot of crud on them too. Ink or other debris can short two nearby pins. I'd clean the ends very carefully with alcohol, making sure that it dries, and that you got all of the residue of whatever's on there. Try your connection again, and you may not even need to replace them.

If you do, I got a very reasonable price, and always excellent service, from Jordan at Solvent Inkjet/Signage Specialist just recently. I'll be doing the ribbon replacement by this Friday as well!
 
You must log in or register to reply here.
Top