Window Perf Virgin

[Bly]

How do you pop bubbles in perf?

 

[TheSnowman]

I don't see how you could get bubbles in perf, let alone have a need to pop one. There's a ton of holes already "popped" for you.

I'm with the OP and I've never done window perf before either. I was asked to quote a job, and I'm trying to decide to laminate, or not laminate, and what to quote per sq ft. installed. I may sub out the prints, I haven't decided yet. If I don't laminate, I'll probably do them in house.

I have (6) 45" X 91.5" windows to put perf on. How long should I tell them it'll last if I do/don't laminate it. I'd be printing solvent ink on clear focus. These are in the sun half of every day.

 

[2 see signz]

do any of you guys have a "terms and conditions" printout that use to get your customer to sign? eg: rear windows of cars, the reduced viability from it, life span, ect...

 

[S'N'S]

I just did my first job with unlaminated perf, was 2 panels 10'x4' each and had to be lined up exactly(outside on shop window). I did them wet to aid lining up, plus the fact it was a bit windy, but went on fine, just squeegee the crap out of it to get all the app fluid out, let dry for a while and go back out the whole thing again to make sure its all stuck down. (I didn't use anything on the edges and it stuck fine) Pretty easy to work with.

 

[Wiggum PI]

do any of you guys have a "terms and conditions" printout that use to get your customer to sign? eg: rear windows of cars, the reduced viability from it, life span, ect...

I can send you the care instructions along with all the other stuff I have from One Way Vision Australia if you PM me your email.

Chris.

 

[SIGNTIME]

do it dry and with no lam then trim off 1/4" of the edge away from the edge of the window

 

[ironchef]

Anyone try grimcos bright line perf?... if not what is everyone's preference.

 

[BigfishDM]

Anyone try grimcos bright line perf?... if not what is everyone's preference.

If you don't love my perf you won't pay for it! 54" and 60" lots of good reviews in here on it. It's priced at $.50 sq.ft also it's hard to beat

 

[ironchef]

Oh my bad. I haven't read the thread yet. Lol. Just asked a question. Hold up...

 

[BigfishDM]

Oh my bad. I haven't read the thread yet. Lol. Just asked a question. Hold up...

Lol no problem man.

 

[ironchef]

Alot of options. 1mm holes 2mm holes. 50/50 60/40 70/30. What do you recommend for store windows? Vehicles?

 

[BigfishDM]

Alot of options. 1mm holes 2mm holes. 50/50 60/40 70/30. What do you recommend for store windows? Vehicles?

60/40 for both small 1mm holes

 

[ironchef]

There's only a profile for jv33. I have cjv30. That's ok.right?

 

[skdave]

I just finished a PERF job that we installed on the inside The perf was pricey but I like the look not being on the outside of the glass.

 

[ironchef]

Nice. Post a pic please