Recent content by Hueyville

Gerber was kind and sent me some service manuals along with a phone call from a tech with advice where to start troubleshooting. Issue is only been in shop for a half day since as doctors want all the muscles they cut getting the big tumor out of my back to heal more. Wife had me do what should...

Will start chasing as many small issues as possible. Have purchased Gerber IVb, Gerber Scanner 1, Sprint 15" & 30", SuperSprint 15" & 30", two HS15+, one HS750+, two Edge printers, Maxx printer and the Sabre 408 router. Counting materials and consumables easily spent over a million dollars with...

I have a Sabre 408 that has run perfectly forever except one time a board in the control box went bad and a limit switch broken when we were a Gerber Beta Test Shop. We got all new firmware, updates, software upgrades first top test in shop environment and issues were not uncommon but at time I...

Plug and all connections in serial plug seem good. Unless have a bad wire in the cable have ruled the plug out. They have some really big ferrite beads on the wires in the control panel so before I dig too deep into removing the cable and checking ohms on the wires (my luck if bad wire will have...

Yes. I seem to remember bumping into the keypad about a year ago and knocking it loose. Plugged it back up and had zero issues but have checked it. The plug is held to the control panel with two screws so when it takes a whack instead of coming unplugged the AMP connector (name brand) on serial...

Have missed most of past 18 months dealing with both broken spine and second bought of cancer. Only been taking the odd job when my health allows and client is patient. Have another such job so came in and plugged up the Spindle Controller, Electrical Cabinet and Vacuum Motor on my Gerber Sabre...