Recent content by Innovative Vinyl

How do you all feel about this layout for a business card. It's ok, say what you will, I'm a big boy. I had a customer come to me and ask for a logo and business name (no need to list all the reasons someone should come up with their own name). The only thing they had for initial input was...

thanks for the help, the blur did a pretty good job of hiding it.

No ones seen this before, I'm still fighting it. I think I've tried everything and still have the same results everytime.

I've never had a problem with them. I actually tell customers to turn it on while they are on the way over (during the cold months). Helps warm the window for application.

I'm in Signlab and have some lettering that I'm using a wood grain fill with and I keep getting off white pixels along the edge of my lettering after I give it a bevel boss effect. The lettering is fine until the bevel boss is used. Has anyone ran into this and/or have a fix for it. Thanks...

I've been using this setup for 4 years now. Holds 16", 6" and 1" on top along with 24" on the bottom. I place my work on the table, pull my mask across and stick it to the table and squeegee it on. I had been using a 12" plastic squeegee with good results most of the time, but as of...

How much downforce are using to cut 6 mil wall vinyl? I did a test cut on my plotter at 5.81 oz and it wasn't enough. The final cut is going to be made on an sp300i. Thanks for any help.

I recently started using Sign Lab 8. After doing so I watched the demo video provided on their website. In the demo video they use a wood fill from what appears to be a Wooden Wonders file. Does anyone know where I can get these fills from. I've checked the file folders and to my...

I have a customer looking for two lines of lettering to be placed on a living room wall. Similar to Upper Case Living. I was thinking about trying it on 3268 but my concern is that a mask will be needed to apply these lines to the wall, but then the lettering won't release from the mask. I...

thats what I had planned on picking up, but for another $100, I thought I would get some thoughts on it.

Hi there. I've just started dabbling in wraps and seen yesterday that Feller's has Bad Wraps for $399. My question would be, is this a much better tool than using line drawn templates? I own and have used some line drawings in the past and they seem to work just fine. I have also taken...

flexi signpro 8.6, ink and some media

SW just quoted me 14995 for a 48" prism jet and a Q54 cutter. with $1000 shipping

I like the price on your equipment Ricky. Are you sure that's the 300i they are quoting and not the 300v.

I'm in Lincoln, I would guess 7 hours from you