Recent content by jeffdpia

I have the same issue with my FC-8600-160. Right side is fine and not cutting through on the left side. Did you find a fix?

Looking for folks who are using the latest firmware update PLS_32_22_23.7 in their 800w machines. Was anything broken in this revision? Just curious as my last update killed the media advance. Thanks all

These machines run and run. You have $1000 of ink right there!

That firmware is buggy and they know it. Re download the previous version and install it from a usb stick.

Narrowed down for this media DreamScape Caviar with bad coating (lines in the coating transmitting right through the ink). 4 rolls in the same lot # with other perfectly fine rolls.

I'll try a reduction in vacuum this morning.

We have the sane thing happening with our 360 using a variety of media. I believe its from the heater elements needing replacing. we just took apart the heater box and unplugged all the small holes which were filled with latex ink dust. That helped but did not eliminate the issue. I have a tech...

FWIW Open bed UV Flatbed printers create an huge invisible cloud of micro droplets as they work. They permeate the air and land on everything in the vicinity. Becoming sensitized to these or other chemicals by contact or inhalation is not uncommon globally. Protect operators; Long sleeves and...

We ran diag. on the motor and it’s broken.I know about the profiles but this is not related.

Take up motor is being replaced, hopefully tension will return to the take up spool.

Referring to print zone temp and print zone airflow? Print zone temp at 108 maximum is 113. Airflow is at 450 maximum is 750 cm/s

Tension is set to 8 but HP is adamant to not increase the tension saying that tension is like pulling the media along. Waiting to hear back. many prints were already produced just fine, its just happening with a heavy ink load across the print area

So I have been printing a job on the 60" version of this material in 8 pass 110% ink-vacuum @50 and have had the ink scraping the leading upper edge of the curing unit. Hp said to lower the curing temp from 195 to 180 which helped until I got to a dark section with full ink load. Does anyone run...

just to follow up, replaced Y/M head after shaking up the ink box and sub tank. Two hard cleanings and voila, full strength yellow ( not quite as instantaneous as voila )

Just 2 machines I know of in the area.