I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Hi guys,
Anyone else having issues with the 360 going to sleep? I keep getting an error message about the current firmware and if the problem persists to reinstall the firmware. I have done that 3 times but now the machine constantly wakes itself up from sleep or doesn't go to sleep. Have the...
Hi guys,
We had a rep come by telling us about DG Cal vinyl to run on our latex and solvent printers. Has anyone had experience with these? What do you think? We are looking at DG PSF100-GG.
Thanks, Steve
Could you create a new profile with a higher saturation level to mimic the double-print? We have an HP360 too but on our Roland we can overprint 2 or even 3 times.
I think I figured it out. The heat settings in the default profile were set to 230C, I bumped up to 241C and added an interpass delay. The streaking was so feint you could barely see it coming off the printer but it was more noticeable after being packed tight on the take up core and unrolled...
Hi everyone,
We recently printed a job with a large number of 36 x 60" signs on Orafol 3640 Matte with our HP Latex 360. It printed well but afterwards we noticed some vertical streaking where the ink was still a bit damp. It was very inconsistent though, it happened in different places and at...
Hi guys, does anyone recommend a printable reflective with a very good white point? We use 3M IJ680CR and also looking at Oracal 5650RA but they're on the slightly greyer side as the base for printing, are there any others out there that are 'whiter'? Client is asking but we need to print on it...
Hi Brandon,
I saw a post you had made about printing 12oz banner on the HP Latex 360. I'm runing some banners at 192C heat with 1500 interpass delay (4 pass print profile) yet the dark areas of ink aren't quite drying - when you run a cotton glove over them you get the inky-film that come off...
We print the colour bands to the left side of almost every print that we do on our HP360. Not sure if it is related to this but we have had hardly any colour drop out issues since we started doing this, before we had issues with magenta acting up. It helps runs the other colours a little.
Hi everyone,
I am trying to colour calibrate a profile on Versaworks 5.5.1 with our Roland SolJet Pro 4 XR-640 using an EFI ES-2000 (GretagMacbeth EyeOne). I have tried printing the measurement chart at a bunch of sizes from 100-175% yet when I try to measure the chart every time I get the...
Hi everyone,
We currently use a Graphtec FC 8000 to plot mostly vinyl (and some experimental card projects) but we are exploring the option of getting a small flatbed cutter, possibly 4 x 4', that would allow us to also cut substrates such as acrylic, lexan, sintra and di-bond. No more than 1"...
How did it turn out? I just ran a test and found that the image is very feint (I guess the ink soaks into the paper) and it's quite smelly. Other than that it did cure properly however.
Hi everyone,
Has anyone successfully printed on a digital sheet with a wide format printer? It's just an experiment for a job, we have a latex and eco-solvent and I was trying to print 80lb Cougar Cover on our Roland SolJet Pro 4 XR-640, has anyone pulled this off before?
Steve
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.