Recent content by theshop9100

Didn't help my situation however, was not able to get all of the cleaning fluid to pump out of the black line. Solventinkjet says because the membrane inside the head is broken and not allowing enough suction for it to pull through. Is this the same gasket you were talking about in my other...

I ended up manually going through the menu and figuring out how to make it start the initial charge

Hey everybody, I was in the middle of doing a head wash on my mutoh 1624, (I've never done one before so I really dont know what I'm doing) but everything seemed to be going good. Then it beeps and says (kcmy) no cartridge. Does this just mean it's done? I put the cleaning cartridges back in...

Solventinkjet suggested running some cleaning cartridges through it on a longstore, and the tech on the fellers line said it sounds like the pump, but its brand new... I'm wondering if I should maybe try to switch the dampers around and see if the missing blue or yellow will print in the place...

Does anyone know anything about the gasket between the dampers and the print head on a mutoh 1624? I've been told this may be my problem with missing ink channels, but I dont have any experience with the gasket. Is it a part that can be changed or is it just made onto the printhead? Is there a...

Here are my last few nozzle checks, I know they are hard to see, sorry about that. And a picture of the lines incase I'm missing something. The checks are sort of sparatic the second chanel of black and magenta kinda want to come and go.

Sorry, not really an expert here, so a little confused. The only o rings I know of are the ones that come inside the new dampers. Is that what were talking about? And cutting an 1/8" off the ink lines that go in the top of them?

it's an OEM maintenance station from solventinkjet, I learned my lesson on the cheapo ones years ago. I checked to make sure, and I can see ink pumping through the lines when it cleans. I dont have any experience with the gasket, is that a part that can be changed? The dampers do seem to have...

I haven't noticed any air in the lines that go to the dampers, but I do remember noticing some air bubbles in the lines under the maintenance station when I was pulling ink through with the syringe, not sure if that's a problem though?

Hello everybody, y'all have helped me before, I'm hoping you can again. I'll try my best to give all the details of what is going on. The printer had been leaking ink out of the head for a while, so a few weeks ago I put a new set of dampers in, but when i did, I couldnt get it to pull ink...

I changed the IP works perfect now! Thanks Vander J!

Hey guys, I'm trying to run 2 printers at the same time but I'm not smart enough to do it, thought maybe yall could help. I have a Mutoh 1614 and a Mutoh 1624. Onyx poster shop 12. My question is, I guess, do I have to have 2 separate ethernet ports to make this work? I've tried a switch but...

Thank you!

Could you send that manual to me also please. Thanks so much. Theshop9100@gmail.com

I've cleaned everything except the encoder strip. Is there anything special I need to know about it?: