Recent content by tnawards

https://www.digiprint-supplies.com/en

Have you looked here...

Turn the heat completely off and run a small test piece and see what happens. Look at the backing and see if it appears to be on there correctly before you run it.

What's a Google, a Yahoo, lol?

Amen on that brother!

Craig, Youtube is your friend. JDS Industries has many videos on color filling different types of substrates. There are many other helpful videos by others as well. Take an hour and you can learn a lot. Good luck!

Good Morning, For me its always been a static issue. I slow the print speed. Clean your encoder strip then run environmental match. Maybe that will help.

You could pull some ink through the M/Y head if you have a syringe. Just go slow.

https://us.digiprint-supplies.com/en/vs-640i-assy-panel-board-w702406010-pboro20290

Did you try here: https://www.digiprint-supplies.com/en/

If you have any doubts just put them on a slightly inclined smooth surface and watch which way they roll. Rolls straight = inside, rolls left it goes on right side if you are facing printer, rolls right goes on left side facing printer.

Hello All, I did a search but came up empty on best print method for gym wall padding. Would it be best to direct print directly on the pad or print on vinyl, laminate and stick on? Not sure how either would hold up against use. Thanks....

Could the firmware possibly be corrupted? Can it be updated or reloaded without a network or compter connection?

We thought about that but the dealer only has a vp as a demo....I don't mind paying if I have to but what bothers me is the no refund if thats not the part needed.....

Hello all, I am having a major issue that is turning in to a major headache. I have a Sp-540v connected via crossover cable directly to a computer. This setup has worked flawlessly for 2 years. Recently after a power outage the printer has lost communication with the printer. NetTools shows...