I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
"So, are you using a flange fit or saddle ??"
honestly, i do not know anything about this. i am a designer/printer, but a i had a good customer ask me to make this sign for them, and they would install the pole and sign, i am just trying to figure out what is needed to give them the correct...
pole will be 7ft above ground, with a 3'x8' sign mounted on a single pole, making it a total of 10ft high. standard double sided aluminum sign light box. i was figuring a 4" pole, probably steel, maybe aluminum but doubtful. i tried finding some footing calculators but they want a lot more...
thank you! not sure why i did not see that option earlier. i did have a roll in with the clamps down... anyways thanks again. the heads were clean as a whistle no build up whatsoever of dry ink on the edges like my old sp300v.
i cannot get to the menu to allow the heads to travel to the left for me to manually clean?? its driving me nuts. its like the option has disappeared from my menu.
i went to "Sub Menu" then to "Maintenance"
the only options i get are wiper, felt, or knife replacement???
i know this is...
thank you for your suggestions.
i got a great roland tech on the phone, he could look up the error code. turns out it was a communication error. unplugging the cat 5 cable and reconnecting it solved the issue. i might have bumped it some how when i was near the machine, and it only stopped...
the printer just stopped half way through a cut today. cancelled the print, i then got the Internal Error code 1942575. shut off the main power and disconnected the cord for a couple min. plugged back in and i can no longer get the printer to do anything. it stays stuck on now processing...
for the past 2 months i have been in the process of trying to learn how to rebuild the scan motors and could use some bad cores. i broke some parts on my only bad motor, its trial and error i guess. i did get it rebuilt and put back together. i also bench tested it and it sounded great, but...
i have a new vs540i and i have my cut speeds down to 10 which is a good speed for me, but in between cuts it scans to the next cut so fast it jams up my prints or makes it go off track.
anyone know how to slow this down, i can't seem to find the menu for it.
thanks
help would be greatly appreciated.
its just showing the generic corel thumbnail for all my files. i can't see my work! just the file names and it is taking forever to get stuff done... i installed the corel cd and tried a repair with no luck.... i did just have corel fixed. it was getting...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.