Search results

I have a vj 1204 and when i send a job it say warming up but it doesn't start printing . I would have to start it by pressing the menu key and enter. What can cause this and how to fix it?

i know how to take it out and install the new board.. after i do how to i get the firmware on the board?

i have a new mainboard for the roland SC-545EX printer sojet 2 v. What i have to do to get it install as the other board is burned out.

Where can i buy this board from?

Where are the fuses on the inlet? what is the inlet?

Hi i am looking for a heater control board for a vj1204. I am getting a 079 err commu. Was told it could be the board.. any other ideas?

Hi i think the valves is bad but i run the lines straight and did a clean and i get good nozzle check and it is printing. when i pull out the cartridge i hear a click now but before i wasn't hearing anything. I will look for the valves and replace them.

Can something tell me how to change the dampers on a vj1324? i am trying to get the ink pull down to the dampers, i try pulling with a y connection but it have pressure but no ink is coming. Any help?

i buy a vj1324 and it didn't come with a waste tank and when i turn on the printing it is saying full waste tank. is there a way i can by pass it? and use a normal bottle or do i have to buy a waste bottle. if so where can i buy it from?

is it a normal cable or a special cable? I had the heater board look at it didn't find anything wrong with it... i will try to change the cable from the board to the control board as i pull it out last time and it work but not sure if that was the fix.

Hi .. printing gone back not working with the same error. Any ideas

can anyone help me for the cables for the vinyl express q130 plotter. The cables that go from the control panel to the main board also the cable from the main board to the head board.

Thanks... i tried what RG said and it came on and print. I have it in sleep mode until i have to print again. I have a new panel cable i will see how to replace it.

I have a vj1204 printer, it was printing and it shut down by it shelf. when i press the power button it isn't coming on. The day before i was getting a 079 err commu error and i took out the memory and re seat it and it came on and i printed then this happen. Any idea on what caused it and how...

How do you turn off the axis Alignment? The manual is saying that registration mark mode has not being enable, that it am seeing Axis Alignment. So i would like to know how to i change it from axis alignment to the ARMS. Any Idea?

Yes it seem it isn't picking up the ARMS. When i go to (INITIAL MENU) i am not seeing it there or when i press the Axis/Ams botton i only get the axis position 1 . Do you know what i would have to put in the search to get the tread?

NO i have them 2 inches from the roller. How can i get the arms menu when you press the AXIS/ARM botton? When i send the contour job it don't read like before just start to cut.

I have a vinyl express Q130 plotter , not sure which model graphtec it is. I would contour cut with it good but this time is giving me a mark scan error and it is going over the first mark but not picking it up. I reset the plotter and now when i press the axis bottom is it giving me a axis...

I Change the head cables and it print the nozzle test, when i send a print it print the image but with the same lines over it. Could the cr cables want changing or the printhead for sure?

Did a print this morning and down send something to print and it print this band of lines. Is t his the printhead fail or cables?