Search results

Does the head carriage make a violent move either left or right and then the error, or simply turn on and error?

Did you check to make sure the CR Encoder strip is aligned? Sometimes if it's off by just a hair the sensor gets agitated and boom. CR Encoder strip protective coating removed? CR motor belt look ok? Lastly, CR Encoder nice and tight? Is it having the error at the same spot when this...

That's the guy, for other models the part # is DF-43968, chances are they are the same part. If you need help getting one, let me know. Also, if you are using the bulk cartridges that has a contact to that part inside, with the card being installed on the outside, remove the cards before...

Why do you print with the cards installed? I use a cartridge that contacts that part inside the machine and has an external port for the card. After the machine is booted up, I remove the smart card.

Ink ID Board Assembly, at least that's what they are named for a Mutoh 1604. A little tricky, but not difficult.

I can attest to that machine, been using it for five years now. No issues.

^^^ This. I use this product with a 1/3" permanent/re-useable tape for application.

I am using a system with floats and purchase third party ink at a large savings. The big problem was finding a smart card chip that worked with the machine. If you need any further info PM me.

I went with N.Glantz Bemesh. Backer has some issues with not wanting to come off especially where black is applied and allowed to dry. Sure beats the backer falling off during a 5'x30' banner ruining the job though. Using a hair drier on the backer does help its release.

I have tried raising the ink limit within the banner profile to good results. I also use an infrared drier.

Neschen Apollo Flag material is the best I have tried, but it just doesn't get the ink "push" as does dye sublimation. I quit printing on fabric when we outsourced our material jobs, such as feather flags. I use Mutoh eco solv.

Try a head soak with a poly rag and cleaning solution. Place the rag on top of the capping station sponge folded over once or twice, dose with cleaning solution. Park the print head there by placing it in the high position until the head is locked in then put on low. Keep your lid open so the...

Had the same problem until we created our own profile with the grey scale being neutral. When I have a bright color like lime green or a few others like hot pink I usually try a small test print with a CMYK file and an RGB file. I found better luck using the RGB for vivid colors. CMYK...

Their is an optical eye in the middle of the machine that needs to be covered up by media. If the media does not cover it it will give that message, ie media that is too far towards the right looking at the machine, thus not covering the eye. Could you tell me the width of materials used when...

I'll trade ya dogs, ours likes to chew on the vinyl!

Another thumbs up for the JetFlex matte.

Power the machine off, hold + - and right buttons down and power up holding until the initialize screen displays then it will read Check 1: Adj. Platen. You can then let up on the buttons and scroll > to Check 8: Parameter, ENTER, should read Param1: Initialize, ENTER, > to Init. 8: Pump...

We have used both and with different results. JetFlex is South Korea and does better outdoors. The SuperPrint Plus is China and gets destroyed outdoors easily. SuperPrint Plus has a better whie point and the prints generaly look better because of this. Another issue with SuperPrint Plus is...

Limit is four units, yes you would have to add another computer and another copy of Wasatch.