Search results

I second Magnum. Overall their material will have the best quality. Yes, I have had defective material from them but not to the same degree as other magnetic manufacturers.

GF Concept 105. All we use.

Try Nite. http://www.nite.co.kr/product/product_c_select.asp?product_a=2&bulk_select=3 That link should give you several options. Find the one that will work with your Roland. Its in Korea and if you buy one you pay international shipping but its still cheaper than buying one here in the...

PM sent

We switched to STS. No problems with the inks. You shouldn't have to re-profile your printers. There were slight color changes with the STS ink but I mean very slight. Most people wouldn't notice. Where we ran into initial problems with the printers was due to the bulk systems. It took us a...

Just to clarify, the pouch type cartridge works the same way a regular ink cartridge does. It has the foil pouch on the inside but in this case it is fed from the bulk reservoir.

We switched off of Mutoh inks around 3 years ago. You will need the NAPIS-B15 IP SC 4S. This is the 4 bulk tanks with the 4 pouch type cartridges. Do not get the float type cartridges. They work but are messy. You may be able to find a better price through a vendor here in the US. I bought...

Nite Bulk Ink System (http://www.nite.co.kr/product/product_c_select.asp?product_a=2&bulk_select=3) You can get a chip charger and smart cards from www.solventcartridges.com. Thats what I do anyway. Lots of good 3rd party bulk inks out there. STS and Jetbest to name a few.

I second FatCat. All our Mutoh's are on the Knite Bulk Ink System. We also bought a smart card charger along with the smart cards/codes from sovlentcartridges.com. JetBest has good prices on bulk ink and the ink works great. No issues.

Using the same profile?

Had this happen on the 1638's older brother the 1618 several times. Every time it needed the CR cables replaced. Is it erroring out on you at all?

Intermittent Head Heat Error is due to the CR Cables. Constant Head Heat error is either the head or the Main board. The problem is "almost" never the CR board. When I say almost, it is extremely rare for the CR board to go bad.

I regularly order General Formulations Concept 202 in 30" widths. (GF202-30)

Primarily for magnetics but also quite a bit of self-adhesive vinyl, cardboard, coroplast, pvc sign board, and banners.

Not on the S3. We did from time to time on our older S800 but only when there weren't reg marks close to the break.

S3 owner here......we haven't had any issues on cuts longer than the bed. Like was previously mentioned, the more regmarks the better.

Marabu makes a liquid laminator called the StarLam 1600. We bought one a few months back and it works great. The worst thing about it is the cleanup. http://www.lexjet.com/i-15865-ClearStar-StarLam-1600R-Liquid-Laminator-STARLAM1600.aspx

Check your network cable. When we moved to our new facility my Mutoh's did the exact same thing. Turns out it was a bad network cable in the wall. We replaced it and it fixed the problem. Just a thought.

There is also a way to do it through the firmware without removing and sending off the mainboard. I would research that way first.

We print on DigiMag every day and have had maybe two fly-offs in the last 3 years. Both were due to improper installation on the customers side of things.