Search results

And regarding car-wrapping UV inks are (mostly) less stretchable than latex and solvent based inks.

UV is a thick layer of ink which can’t be laminated without shadows. Latex can be laminated immediately. Solvent based inks needs time to evaporate all components and might affect stickiness of laminate.

If you’d like to print for indoor usage check out non smelling inks. Latex would fit. Outdoor non laminated go for UV. Small stickers with text go for eco-solvent. There is no machine that can do all at same time.

Rfid board is different between FF and OCE. Manufacturer is also stored on HDD, DataRelay and SystemControl pca. If one is replaced it gets the code of the two others. What do you need are two oce rfid pca, a backup of your registry, a registry of exact same Océ model and a data relay of exact...

Reset the CLC to factory valuesand redo it. Maybe database get corrupted.

In the log you’ve sent you can see lots of link errors to carriage. I would suggest to reseat both sides in carriage and behind the big cover where the ink filters are located. and clean the contacts with contact cleaner first. Check logs afterwards regarding carriage link errors.

Mistake: delete the color reference

!!!with known good printheads!

Then delete once the embedded icc and recalibrate. It can happen if one color reference has been created under suspicious conditions that the table gets corrupted.

Have you activated color consistency mode in media preset? This stabilizes temperature of PH and heaters more precisely.

Sometimes the truth is timesaving. This kind of debris is normal since there is a gap in between printhead and carriage bottom plate. This residual ink can gat in contact with the exposed printhead connector. Thats why you have received a tool in the printer cleaning kit, that comes with the...

As I can see you are not very experienced in technical troubleshooting. And the knowledge you gathered during installation training and ramp-up is poor. I could recommend you some points, but it would take to long. My advice is to call your sales/service company and let them check for you. If...

Is the magnet screw well fixed?

HP Ink cartridges are under warranty until depleted or expired. Just return it to the seller. Check also the connector and electronic on the back of the printer. Could be ink on electronic or broken holder.

This is quite an oldtimer. Download a service manual somewhere and do the limit initialize.

Little bit Magenta + more yellow = orange…

Could be cross contamination through capping or damaged sealing inside printhead. Is ink also mixed in dampener? Check if capping pump is working.

Logically, the amount of ink printed has a direct impact on saturation and density. You would see it if there is a difference…

What a stupid question. Put the original file into the other RIP. Ripped files have resolution dependent pixel and color information inside prepared for the printer and printhead configuration. Sure, you will have color differences unless you do color calibration on both devices. Also, your...

But you don’t need to remove the cover, because you can disconnect cable at the line sensor. Unclip by pushing the connector frame upward.