Search results

Clean the encoder strip along scan axis with WATER and check em for scratches or damages. If that doesn’t solve the issue change scan axis motor.

Check your right roll holder. Sometimes the lower bearing runs out of position and produces high friction to input spindle. Also position of input spindle changes in this case.

All my XT‘s I’ve moved without the crate. The two tables are not a problem at all, and the e-box with gantry can easily be fixed with straps. There is no need for the crates! Every relocation company can do this.

Where the machine is coming from and where should it be installed?

depends on the substrate you’re going to use. 1000W milling or 300W? Table size? Textile? Carbon? Plexi? Finish with diamond bit?

If it’s on all media I would try to get help from Mimaki through the sales company. If they can’t solve it machine needs to be replaced immediately. Have bou the machine with „soft media kit“?

Which RIP u are using? Try first with Rasterlink. Who sold the machine and RIP? They are responsible for any warranty.

Exchange the network cable to cat5 or 6. And connect it directly to data relay pca without the f... adapter. This frequently causes errors

A good solution might be to buy them from littelfuse (written correctly).

And why not mixing a true flatbed JFX200 with a latex r2r? Depending on your usage a true flatbed could be better then a belt-based unit...

If you have CA3, good for you. But CA4 works also, but with parameters of CA3.

I would suggest for the very first head replacement to get a experienced engineer and learn it by asking. If you have seen it once you know. It’s too much to explain by writing. For ordering i would suggest digiprintsupplies, if they still have. And the engineer is agree with. Océ doesn’t have...

Only white ink pump may cause this. Brushes are not meant to last 4ever, and white pump is used for recirculating. What errors you can find in message box? Or can you provide the error logs from tools tab?

You are not in need of a dongle. Connect a usb keyboard, ctrl-alt-del, stop the software and regedit the values. You will find them in area "Oce Aries".

Engineering dongle But a question: where is your dongle from? you'd like to sell it? Or do you have access to service dongles? Expired ones maybe?

Head heght during purge Why the hell you raise the head on purging? Ink will spill everywhere around purge bucket... I keep the carriage in low purge position and clean the heads also in this position. There is space enpough. Have you found the setting for using expired ink longer then you are...

Connect a Keyboard to USB, press Ctrl-Alt-Del and shutdown the Printer app. With mice go to Startmenu - Run and enter regedit. Then search for entry with serial, voltages and the AL-value and write it in. Restart Printer app located on Desktop and you are done.

Ink heat timeouts are normaly because of insufficent circulation of coolant fluid. Check pump and dampener in the right side of gantry. Or maybe one of the triac boards has blown. Heaters can be checked by Hand. There are a heater in the carriage and near the coolant pump.

Printouts on a Latex 360 are not as sharp and detailed as on a solvent Roland or Mimaki. For outdoorit is very good, but for small Stickers it doesn't

Use an airgun with ionized air, available in the web, and blow over the media. Use a grounding strap from Aluminium overlay to defined potential. Use a grounded brush with carbon fibres to eliminate surface static.