Search results

Depends on you skill's level and experience, dear))) We use to the different kind of service and engineering philosophy in Russia.

For sure - you won't need the new one. Electronics made by roland is really robust and reliable. Yes, correct. But still cannot get why do you think that you will need it? BTW, there are also special function to load factory defaults biuld-in into MB firmware so you can perform it from you MB...

Check them out: Bordeaux Israel, InkTeck Korea, Nazdar/Lyson USA/UK, SunChemical UK. The only ones i can really recommend. It's not surprising me that transistors are "burned" or in short. Means PH is dead 150%. Why do you need to upload MB parameters? It's not necessary if you replace PH or...

WTF? It's total 666% bullshit! KM 1024i has 6pl drop size, which is a regular industry standard now. If you in doubt about its print quality then check SwissQprint Nyala 2 or 3 printers. 217 sq.m./h. by 2 passes with the outstanding quality prints without any banding or any other "usual UV...

First of all, no matter which version of corel you use to. Flexi 12 itself works perfectly on Win 10 x64 which I can strictly recommend. You can also concider onyx for instance.

Tony, I've done it hudreds of time in my life. The problem is when you change the flat cable with the new one using the same channel you never know is there a PH or board promblem if issue still persists. Thas why you should swap 100% OK channel with smth non-100%-OK.

Hahaha, why?

Cariage Board )))

Can't say that it's good for you but i doesnt look as a big proble though. Try following. Remove the Y-channel cable and insert the K-channel cable from the Car.Bor. to the Y-channel PH. Then try to print just K square. We'll see then.

Have Dongles for sale: Onyx 18 #Thrive Onyx 18 Production House Email cmyk.nc@pm.me PayPal or Bank transfer only

In most of the cases the noise sourse is a Y motor. You can actually replace the bearings inside of it, ofc in case you at least have some experience. Don't listen to that guys, you should NEVER apply any on a rail directly. You can add some to the inner chamber of the liner bearing but be be...

There is a short circuit in a printhead or in a PH cables or just a connection issue between PH-cables-carriage board

It's impossible unfortunately, only replacement is an option.

Nazdar 705 are really cool. Better than HP in adhesion for sure and its White is really saturated. Use them for about two years.

Sirynge is your friend for now :) there is also might be some problems with connections.

Sorry for the off the topic post though, but is here any place I can search for the open FSE position? :rolleyes: I'm highly experienced in digital inkjet printing as well as digital finishing (ESKO Kongsberg) and so on.

PH is dead for 95% then.

Hi there! It doesn't seem to be a ribbon cable problem at all. If there was a short circuit than it might be a printhead issue.

Don't even try efi. Ferry slow, loads of bugs, pretty week vacuum and to sensitive jam sensors to run on coro. Concider FB, pay your attention to the printing quality. When using without lc lm its output quality rather outdoor than indoor and droplet size stricter to 12pl. Also pretty slow and...

1. Does your prints have the same dull colors as they appear in ergosoft? 2. Seems that you have a different profiles set to display in Ps and Pp.. 3. Try the soft proof : load your printer ICC to Ps and assign it to the file.