Search results

I'm parting out a VJ-1608HS

Flexi 21

I'm sorry I confused you. I misread the part where you are cutting on the xr640. Once your cutting pressures are set to the job you can not change them in midstream. I have two xr640 and only print roll to roll on them. I personally think the cutting system on them sucks and is too expensive to...

If this shop created a logo / wrap design and charged the customer for it, the shop dose not own anything tied to that design.

I wouldn't buy anything from digital again. They don't stand behind anything they sell. I still have a open claim with then for over a year and they won't respond.

Set pressures first before sending job.. When sending job to printer make sure there is no pressures set, only set the type of cut. Then you can change pressure in the middle of job during cutting.

Sounds like the motor is toast. As highrolling24 noted when putting a load on the motor you are putting tension on the shift and bearings which will make it seize up. One way to check this is to put a pair of work gloves on, power motor on and grab with pressure the gear on the motor that the...

I might of figured it out for you. Hope it works.

I think the Graphtec loupe is used to see if there is still a Sharp Tip on your blade not to see how far it is extended.

You Need Flexi 21 for barcode cutting on Graftec 9000

If you are getting any kind of banding in your prints do a thorough cleaning of your Cap tops and Print heads. Do this weekly and your printers will continue to print great for a long time.

Have you cleaned the dried ink off around the edges of the cap tops recently?

Open Design Central in the View drop down menu, Double click on image, Highlight 0.000 in the Design Central Box and type in 45, 90, 180 or whatever angle of rotation you need then press the Tab key

In your photo, bottom left, Next to the Grey countour cut you have mistakenly shut the cut file off. Click on the Red X to turn the cut back on.

Shutter Stock has all you need. Just spend a few more dollars and get the right size file.

Every carrier sorts their own mail for their route. Just let the carrier know or write in Big Red letters delivered to wrong address and put back into mail box, they will pay more attention after that.

My Graftec 9000 is running great. Must have Flexi 21. Set job up, position job to the right side 3" from bottom. In Cut window, select cutter, click on Options in the Registration Mark box, check Use Bar Code. Bar Code Type set to Roll Media, click OK. Send to print. After printing put media on...

Yikes. I never looked. Always do one at a time

That cutter will last you another 20 years

Sorry for the delayed response. Set job up, position job to the right side 3" from bottom. In Cut window, select cutter, click on Options in the Registration Mark box, check Use Bar Code, Bar Code Type set to Roll Media, click OK. Send to print. Hope this works for you.