Search results

This problem happens when something is wrong with the capping station, ink tubes from capping station to the pump or the pump itself. It happens when ink is remaining in that components after cleaning, what creates a slight suction.

The bowing compensation only works with S-Class (since 2005) and SummaCut-R (since 2007).

With the latex 360 you have much more scratch resistance and chemical resistance than with an eco-Solvent printer. Because of much better results on textile banner and lots of different papers (wallpaper too) the machine will fit to your plans for wall coverings and prints on fabric better than...

Thrive should have an option for Roland CJ/SJ-Cropmarks.

Whe have tested Fujifilm Uvijet Z680 Adhesion Promoter on aluminium, and this will increase the scratch resistance very much.

You can do it in Flexi and in Onyx. In Flexi both in the RIP and with the Option "Contour Cutting without RIP" to set registration marks in the editor itself to send the data to VersaWorks and doing contour cutting out of Flexi. But you will not be happy with it. Because of the curing heat...

You need separate profiles for any dither type.

Because of the very high scratch resistance on banner, the motorized roll feed, the automatic control of the feed rate and the possibility to print double sided, I would check a latex 360.

You can't select Passes on the FB, you need to select a higher print mode. About heat: how old are the lamps? You know that when they reduce UV-power, you could switch them from low to high power to compensate that reduction for another few hundred hours? Heat problem could also be a problem of...

Vertical Banding on that machines could have a lot of reasons, mechanical and others. There could be dirt on carriage wheels, carriage rail or linear encoder, damages or wrong calibration of carriage motor or carriage drive belt, problems with the lamp shutters and much more. There is a...

Try to reduce ink limit in the profile.

You're right. In this case, there is just only the old fashioned user interface design :rolleyes:

I have found nothing about that special feature. But it is easy to use.

When buying a latex 310 or 330, you will get a RIP included too ... the SAi FlexiPRINT HP Edition. This is an OEM of the PhotoPRINT SE Low Cost RIP, but with Panelling- and Nesting-Option included. Although PhotoPRINT SE is a low end RIP regarding to other SAi-Products too, you will find a lot...

Davo: Do you own a Latex 360? Only with a 360 ICC-Profiling in the machine is possible. With a 310 or 330, ink limit and linearisation only can be done (an ICC-Profile must be chosen from one downloaded or generic). If you have a 360 and having no access to the ICC-Profiling, I would clone the...

If you want to use a hybrid roll and rigid media printer, and want to print borderless all around and on metal sheets too, carry much higher weights than with the roland, thicker media, automatic media height detection, multiple sheets at one time and loading of additional sheets during...

With the 540 the test print will be KCMYLcLm, with a 545 it will be CMYKLcLm. The Switch Pages are looking plausible.

The resolution of 150, 300 and 600dpi have nothing to do with printing resolution. With these values you set the rendering resolution of the contone-bitmap-file generated in the RIP-Software. The printing resolution depends on the print mode chosen (lnumber of passes). With the new firmware...

Reduce the input tension (driver properties). If that don't help, reduce the vacuum.

I'm shure the installation on Windows 7 is new? Flexi 7 will have the described Problems on Windows 7.