Search results

Great thank you. I had the valuejet 1304 for over 10 years and never had this issue.

hello we just purchased the Mutoh 1624x And we are getting media buckling. I have lowered the heaters to 35 and have made sure the media is loaded properly. It’s starts off good printing fine and then you can see the media starts to buckle and cuase headstriking. Is there other setting i...

Warp the trailer and call it a wrap

3M 480 film.

We remove it in strips about 6-8” wide.

Was the scratch visible? Mine has a scratch where the white plastic like guide touches is all the way around the disk

What’s the proper alignment? Should it be touching the sensor white plastic piece on the sensor?

Yes please tell us how you resolved the issue???

I will try that thank you !

Thanks!

Thank you for your reply. I will check the encoder trip. As for the media Buckling would it be enough to notice it buckling? Thanks again!

hello was hoping someone can tell me what is causing my printer to print like the pic attached. It looks like it lighter in areas. Thanks

Wel if he's pretty set on it then he better be prepared to pay to have that logo redone.

Scam Yup got the exact same email. I told them I only accept cash sorry.

Mirror clips What about using mirror clip hangers. If he means no holes on the ceiling then there's no choice but to use some kind of adhesive. Maybe double sided gorilla tape.

If it's new If you bought it new. How bout have the supplier come on and give you a small training session. I have laminated an entire roll with my seal 54 succesfully time after time. One thing you need to not overlook is the material you are using. If your backing paper is too thin on your...

Time only time Give it time or place it outside on a sunny day and it should disappear.

Flat finish walls Yes I agree flat or matte finish is the kryptonite to vinyl but making customer repaint the wall may not sit well with the customer depending on wall size. I have spoken to a sales rep at WRI supply and they said that when in doubt us wrap vinyl. But laminate it so you can...

Non laminated printed vinyl Yes I agree non laminated printed vinyl Can be a huge headache when installing. You can get away with it you're doing it on a table with wet application or mounting using your laminator. But on the wall I would strongly recommend either masking it for stability...

Vertical installation. You should always work with gravity other than against it. I know that one piece sounds a lot better then panelling but if you do it right then the install should look seem less. Vinyl is going to be better and cleaner then using paper and glue.