Search results

Also seems like with the 25 ft usb it will stay connected. I will leave it today and see how long it stays connected for on usb. Is the red light on back of cutter supposed to be read with the Ethernet cord in only? Mine does not light up. Only with usb connected.

It will scan barcode and cut it. If it does it before it disconnects. Once it disconnects it just stops. I start barcode server button and let it sit and anywhere from 1-10 minutes it will disconnect on its own. I was told it’s a static issue. But shop is humid. I am headed to shop shortly to...

Here is kind of what is going on.

So i just got done hooking everything up to a switch. Barcode server will randomly disconnect from my summa cutter. Any ideas on a fix? It will go from disconnecting disconnected to disabled.

smoothing and opti cut are off. It was the same side of rectangle on all of the. But if i cut straight from signlab it cut it straight.

Did you do the line test? Feed direction.

Is it the feed direction? If so do the line test and measure it i bet its off. Mine was

I will take a look tomorrow. So then for running all Ethernet to a switch. And the modem to the switch? I will have to do some research. Never ran computers and equipment like that before.

I could go to network if I need to. Not sure if you can still use barcode server? Where do I turn off the optimizing and smoothing? On summa itself?

I am almost thinking it is my usb cord. My barcode server keeps disconnecting randomly says no printer connected or something like that. Ordering another usb cord. Have it swapped with my other cutter right now and its working fine on that cord.

I have noticed a lot of bugs in the 18.5 postershop. Pretty annoying as versaworks was really well and free. I hope they fix most of the issues. Even the phone support said there were bugs and you just have to mess with it.

Also when i tried straight from signlab i just cut on 651. When i did the print and cut i was using avery 2105 with lam.

When printing on epson 80600 using onyx posershop and then send cut file to barcode server the rectangle cut line is not straight. If I cut straight from signlab to summa it will cut it out straight. Any ideas of what to fix?

The first post states he upgraded to 10 for signlab

We charge by hourly rate an never had issues. I can see where if you do it really fast where it could undercut you though. I have been doing it long enough I estimate what the install time is and do it at that. Unless its a removal then I charge hourly and make sure i record the whole time so i...

Isn't it just the thickness of the ink. If you print on vinyl and apply it to a substrate and apply a solid color vinyl over that you will see the difference in thickness where the inks are and it shows through.

What signlab are you using?

You ever try using totally awesome? Thing has done me wonders when other cleaners can't.

I just went and removed old lettering. Put up some strips of 180cv3 ij175 avery 1105 and arlon slx. Put 4 on with heat and 4 without. Going to go look at it when we close today.

I would be fine with not laminating. I just need something to stick.