Search results

I managed to clear the error code after installing a used PIP. Why did the magenta ink cartridge get full of air more than normal? the case became so big that is was very hard to remove. Is something wrong with the air system?

Hi, The printer shows error code 26.01:10, Ink leakage detected in Magenta supply and the ink is into the air tube. the magenta ink cartridge looks ok. That magenta PIP must fail. I have a spare L360, so I can switch some parts. I have some questions: 1 . Can the PIP be recovered or repaired...

Hi, thanks for all the help before. For this used Oce Arizona 350GT, I have replaced a motherboard and removed the brackets that secure the carriage and gantry for transport. the printer has passed the installation process. It is ready for coolant and ink, The RMO is not installed yet. Any...

It is my fault totally. I should check the brackets before everything. Thanks for the help! The printer has passed all the processes now. it is ready for the coolant and ink.

found this metal block installed under the carriage yo secure the carriage, which stop carriage to be moved. The printer finally can move the carriage to the waste ink area. Then gantry error. Wondering any similar things for the gantry please? The printer was powered off and serviced by the...

It is a GT model, but the RMO is not attached. So the clutch work like a hand break?

No movement at all if I push gantry beam by hand when power off. Should there any free movement for a working one?

Anyone has service key in uk area?

The printer was powered off by the engineer and a rubber pad was put under the carriage. When I powered on the printer after i replaced a used motherboard, I only got the carriage moving up, then motion error. The carriage only freely moved 2-3cm left and right. Gantry stuck there, no movement.

when power on the printer, 1. it will install and check the hardware, 2. carriage lift up, the printer stuck here then motion error. 3. What is next if the carriage passes the lifing up stage?

Sadly no service key. But will look into the motor brushes, a few topics about this issue. Update later. Thanks

Thanks. I will connect it and try again.

The printer powered on bit nothing on the screen, the motherboard was gone, so I replaced a same model board bought from ebay. The printer can pass the installation of RFID board. Then Initialising Z axis completed. Initialising carriage, it showed motion error after I lift and lower the...

I bought same model board on ebay, installed and power on. The installation of RFID board passed. Thanks for the helps.

The network driver is installed. The RFID board was still not working properly, the software only got once working, then stuck after the cartridge lifted. It kept reminding reset errors. When I restarted the printer, the RFID board installation failed again like before. Is it because the...

I connect a very old USB keyboard, then i can use ctl+alt+del to stop the oce software, then i can see the other information. It reminds me the Intel 2567V-2 Gigabit network Connection is missing. How to install the driver please?

thanks, I will try to find the missing drivers. I forgot how to use XP system, and google it.

Hi guys, I installed a motherboard from my old xp pc on the printer. after it powered on, it reminded me that the printer is undefined. RFID board initialization failed. then I click the Diagnostic screen, update a Calgary Platform 4.18.0.14 Setup, it passed the installation, 350GT image showed...

I just installed the printer's hard drive on my old WinXP pc. the pc can be powered on and log in WinXP system. but the mouse can do nothing until the software opens. then it pops out the reminder information. i can not click anything else except the software, is it normal? if so, can I...

I tried with my working pc power supply unit, same problem with no display. I will to remove the motherboard from the printer, clean it as you suggest, see what happens. I do replace the button battery, the old one is 2.8V, new one is 3.2V.