Search results

on the sp the magenta/yellow is the same head.

vw profiles if you go to the media site they usually have profiles for thier media Example: http://www.oracal.com/knowledge/icc-profiles.asp

Segoe Print (Regular)

URW Albireo TLig (Regular)

seriously I would machine cut on a plotter - I can't see anyone paying for dies to be made for a small quantiy . . . . would be cost prohibitive :noway: die cut is right up there with not knowing the difference between a clip and a magazine. makes me twitch every time I read it

glad that was it

Did you check the settings I mentioned over there in your flexisign?

I see on another forum you got this corrected using the graphtec cutting controller.

congrats on the great find - went out 2 days ago and got 2 :( hope to get out early next week

solaris My first printer came with solaris inks - though not real bad with ventilation when my bronchitis was acting up it was killer - went back to roland inks and haven't looked back - even less clogging when I don't use it for a week or so - vacations of 2 weeks were sure to have clogs with...

look at post 199 in the signature - the code is there.

sorry for your loss james - when my grandparents passed I found a local chuch that collected non expired meds and with a doctor they gor redistributed to those lesss fortunate. just a thought for others in this position. since leaving the prison environment I have been able to eliminate all my...

add to the overcut in you flexi also

buy it all from them and the support is great

largest I think I can do on the gx7000 is 13x19 - the material to be sublimated to does have to be polyester coated and the coating needs to be very very even for a good print. - special ink and special coated products to print to.

Never heard of Vesta but Hotronix are cast iron solid IMHO. many times you can find the old Hotronix swingers used for under 800.

in that case I would throw a cleancut 60 degree in it - you are cutting partially thru and the cleancut blades I use have to be dialed back to 30 percent less pressure so I would think it might make it the rest of the way thru that material - OldPaint has much more experience than I do, but I...

same here cleancut in the graphtec and roland and all holders - I like to have extra holders pre set for with lam, without lam and reflectives/metalics. Markings on holders aren't pretty but just changing the blade holder for the particular job is quick and easy - I seldone have to do test cut...

soon to be that part of the ocean formerly known as DPRK

properly set up cutter with sharp blade - 1/2" should be easy weeding. what plotter and blade are you using?