Search results

Hello, I posted about this issue a few weeks ago and still haven't solved it, but it has actually gotten worse over time and I have a better picture here to show it. You can see in this image that above the "P" the print becomes grainy and the colors start separating, then the print becomes...

Hello. I've attached an image of the issue, but I am getting these fuzzy horizontal bands about 2 feet into every print I make. I can avoid them by printing a new job immediately after the last, but I let it sit for much longer than a few minutes this band appears on my next print. The image is...

Hello, We have had an issue with our HP latex 110 for a while now, but it has been constrained to just the far left of the printing zone so we have not worried about it. Recently it has started appearing all across the printing zone however. I have tried replacing printheads and ink repeatedly...

Hello. So it seems ever since it started getting really chilly this winter we've begun having issues with our Orajet 3164m developing bubbles, before we even print onto it, and only partway into the roll too which is very inconvenient. We use an HP Latex 110. The room rarely gets below 40 even...

Hello. Occasionally we have been getting these horizontal dashes of what look like indentations/dents in our prints after laminating. They look like laminate bubbles, but they don't appear to have any depth like a bubble would. They don't appear often enough to be too problematic and we don't...

Hello. We have been trying to print some solid orange prints for a few days now, but we've been getting this terrible banding. I've attached a photo below. We use an hp latex 110 with Orafol 3164m vinyl. The room we're printing in has been quite hot lately, upwards of 83 degrees while we've...

Hello, this morning our titan 165 was working perfectly well, but when I turned the machine back on the second time today it began running at full speed, without any controls on the control panel working or affecting it at all. The motor will only stop running when I turn the machine off or the...

Hey I was wondering if anyone had any information on where to purchase black self adhesive vinyl at this dimension. I'm having a really hard time finding anyone who supplies 54" x 50 yards. My laminator is loaded with 54" wide Briteline which is why the specific dimension is needed for the...

We switched internet providers recently and now our HP Latex 110 Is not communicating with Flexi Print. It keeps asking for an administrator to "setup TCP/IP" and every time we go to print it says " cannot open port". Any tech help would be greatly appreciated.