Search results

Thank you so much!!! Did the recalibration and it worked!!

Tried that as well, no change.

Trying to print on 24” wide reflective material. When it goes to do the media initialization it comes back with media end. I tried setting the vinyl to the right and in the center and no difference. I put tape over the sensor in the back as well and that didn’t do anything. Anyone print on 24”...

I did a bunch of designs for another small business and they were specifically for cornhole boards. I have decided to cut ties with this company due to reasons that I don't care to explain, but he wants the designs so they can be reproduced later down the line. Is this something you would do? I...

I did a bunch of designs for another small business and they were specifically for cornhole boards. I have decided to cut ties with this company due to reasons that I don't care to explain, but he wants the designs so they can be reproduced later down the line. Is this something you would do? I...

bought my printer and ink off amazon. no issues at all!

Is the metal cup coated and specifically made for sublimation???

Have 2 screens that have sat for over a year with the emulsion burned into them as I did use the screens. Any special or extra steps I need to do to remove the emulsion other than using emulsion stripper?

Just drove 2 hours and picked one up from them yesterday! Already put it to use and absolutely a game changer for me!

THANK YOU!!!!! :)

Anyone have the S2 T120 that can tell me if 48in or 50in material will fit? I cannot find the T140 (54in) plotter in stock anywhere and I need a new plotter. My printer is Mutoh Vj1204 which prints 48in, but I believe it use 50in material with it. TIA!

Why would my cuts be off this much? Using Flexi with type 2 registration marks. For the life of my I can’t get an accurate cut. Seems since I had vinyl bunch up underneath the head I’ve had this issue. I am at such a loss and have wasted sooo much material.

This is suppose to be grey. I also have one blue nozzle that is not firing at all. Could the incorrect color be caused by this nozzle?

I’ve done both cleaning and 2 little charges. I’ve got one black and one blue nozzle firing.

It also appears that something is wrong with the maintenance station. I’m putting solution on the capping station and it doesn’t go down, it just sits there. When trying to pull it thru the lines, I get a lot of tension on the syringe and it collapses the line

Just replaced printhead and maintenance station. Am not getting any ink to print. I’ve also tried pulling ink thru the drain line with one of the lines closed off. Thinking it may need a new fuse. I have the back covered pulled off but have no clue where the F2 fuse is located.

I did end up finding the other black thing under the vinyl :rolleyes: . So even with printing 30" wide vinyl, it doesn't cover the sensor. So do I need to make sure that I have it slid over enough that is covers the sensor?

Also when trying to initialize media width, get the error undefined media. I do have a piece of vinyl over the sensor and that doesn’t seem to do the trick. Only way I was able to print the color pallete was to enter width myself.

Just bought the printer and trying to get it set up with 30” media just so I can start setting up color profiles, etc. I do have 50” media. Is this supposed to be set up directly in the middle of the platen? Trying to test print and get error Measurement Error (Media Detection). Also, what is...

Thank you so much! That worked!!!