22 kt Engine Turn Gold

[pjfmeister]

I have a small project to make and install some 22kt Engine Turn Gold. I haven't used this stuff in many years. Any tips or warnings other than don't screw it up
Primary concern is
1. tips on cutting 2" letters - plotter setting etc
2. application tape - planned to use clear RTape

 

[tbullo]

I use 1 step lighter pressure on my plotter(graphtec). Here's a link to Real Gold Instructions.

Care & Instructions

A clean substrate is the most important thing for the success of Real Gold vinyl.Area MUST be prepped as follows: Using a microfiber towel, clean the substrate with a mild soap and water. Next, clean the entire surface with 70% ISOPROPYL ALCOHOL If you are putting our material on another vinyl...

realgoldinc.myshopify.com

 

[MikePro]

for tiny lettering, i filet corners @ .01-02" so the tips of sharp lettering don't have hair-thin points.