Anyone have a door measurement for this template?

[Stacey K]

Yes - I measured the door on the truck but I resized my photo and threw out the sheet of paper I had it written on (ughhh). It's a 45-minute drive one way so just trying to save another trip. I can't find a one-off template to purchase.

 

[JBurton]

No chance the customer would re-measure for you? I know there are certainly customers I wouldn't dare ask/trust to get that info for me, but if it's a trucker...

But, I found in this pdf, page 25: http://bodybuilder.navistar.com/Gen...s/20161101/CT471/Series/DuraStar/DuraStar.pdf

 

[ProSignTN]

Just so you can double check

 

[guillermo]

I have done a simple task and it has worked for me all the time..... since I watched a movie.
I will place something that I know what size it is, for example, a credit card, a 6" squeegee or bigger, or the one that works the best, a ruler, tape to the door and take a picture, then I import that into my illustrator app and enlarge it to the size of the ruler. you will be off about .25" to .5". Hope this helps if you call your customer.

 

[thesignpost]

It says its 1/20 scale, scale it up

 

[Geneva Olson]

we always pull in the template and then scale it up to mock up the graphics full size.

 

[Stacey K]

Thanks guys! This helps a lot!!

 

[Stacey K]

It says its 1/20 scale, scale it up

That was just a screenshot of a template from ProOutlines not the actual template

 

[jcskikus]

If you hadn't gotten it, email at john@gettasign.com and I'll just send ya the template. Not a big deal.

 

[myront]

we always pull in the template and then scale it up to mock up the graphics full size.

Same here. I have a macro for corel to scale the template. Yes, easy enough to just type in 2000% but I can right-click and run the macro. I also have another that I can draw a rectangle over an area of known distance i.e. door width, then scale the rectangle to that measurement, shift select the image, run the macro. Scales the photo to match.