• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Need Help Epson s60600 powercord #2 after replacing printhead

T

Tim-moh

New Member
Good morning, I am working on an Epson s60600. Replaced printhead #2 for missing black, cleanings wasn’t helping any. Machine was working ok besides missing nozzles. Followed all step with service tool and service manual, purged lines with cleaning solution, decompress pressure, Shutdown and unplug. After replacing on boot up I am constantly getting plug in powercord message. I have tried resetting cables no change. Any help or suggestions would greatly be appreciated. Thank you
 
N

netsol

Premium Subscriber
is there a second cord for a heater? or some other aux. device?
as i google it, you have 2, possibly 3 power cords (my mutoh has 4, including the takeup reel.)

did you inadvertently disconnect some sort of control cable between the printer and the heater unit?
 
T

Tim-moh

New Member
netsol said:
is there a second cord for a heater? or some other aux. device?
as i google it, you have 2, possibly 3 power cords (my mutoh has 4, including the takeup reel.)

did you inadvertently disconnect some sort of control cable between the printer and the heater unit?
Click to expand...
2 plugs for machine and a third plug for heater. I didn’t unplug anything but the ffc cables for the printhead. I am assuming something shorted and it’s either power supply is bad or mainboard.
 
You must log in or register to reply here.
Top