Mimaki CG-130FX calibrating problem

[MORO]

I have a CG-130FX plotter an the problem I have is that the plotter cuts not accurately. For example, if I cut a rectangle of 100x150cm the cut is 2mm to short over the total length. Can I calibrate the plotter?

Thank you

 

[GraphixGirl79]

Yes, you can adjust the cut length. I noticed this was happening with longer things to cut, so I looked into it and it looked too complicated for me to figure out so found my own method by cutting in lengths no longer than 3feet ish at a time. But it is in the Operations Manual Pg. 3.9 to 3.11.

 

[netsol]

Yes, you can adjust the cut length. I noticed this was happening with longer things to cut, so I looked into it and it looked too complicated for me to figure out so found my own method by cutting in lengths no longer than 3feet ish at a time. But it is in the Operations Manual Pg. 3.9 to 3.11.

shouldn't it be a single potentiometer, perhaps 2?
(2 ADJUSTMENTS, not 2 PAGES)

 

[GraphixGirl79]

like i said.. it sounded complicated. All i can do is share what i've read.