Mimaki CG-130FX calibrating problem

[MORO]

I have a CG-130FX plotter an the problem I have is that the plotter cuts not accurately. For example, if I cut a rectangle of 100x150cm the cut is 2mm to short over the total length. Can I calibrate the plotter?

Thank you

 

[GraphixGirl79]

Yes, you can adjust the cut length. I noticed this was happening with longer things to cut, so I looked into it and it looked too complicated for me to figure out so found my own method by cutting in lengths no longer than 3feet ish at a time. But it is in the Operations Manual Pg. 3.9 to 3.11.

 

[netsol]

Yes, you can adjust the cut length. I noticed this was happening with longer things to cut, so I looked into it and it looked too complicated for me to figure out so found my own method by cutting in lengths no longer than 3feet ish at a time. But it is in the Operations Manual Pg. 3.9 to 3.11.

shouldn't it be a single potentiometer, perhaps 2?
(2 ADJUSTMENTS, not 2 PAGES)

 

[GraphixGirl79]

like i said.. it sounded complicated. All i can do is share what i've read.

 

[cornholio]

No big deal, just mount media, cut the length, measure and enter the difference.
It's more or less the same with all roll cutters. Some want you to enter the absolute length(Summa), Mimaki needs the difference, others want a factor.