Need urgent help. As soon as change the carriage cable, there was issue

[Sum19]

Need urgent help. As soon as change the carriage cable, there was a spark and motor error message, and some smoke came from the back side. What could it be. What do i need to do now. ?
the error is SCAN MOTOR 0010 0010.

 

[netsol]

at one end, it makes a 90 degree bend
did you put the one end in upside down?

 

[Sum19]

at one end, it makes a 90 degree bend
did you put the one end in upside down?

Yes

 

[Sum19]

Got the culprit. I think i fried up one of the part in the board.

 

[Smoke_Jaguar]

That's one exploded 3 phase motor driver. That's like $7!

Hopefully nothing else got zorched in the process.

https://www.digikey.com/en/products/detail/stmicroelectronics/L6234PD/634708

 

[Sum19]

That's one exploded 3 phase motor driver. That's like $7!

Hopefully nothing else got zorched in the process.

https://www.digikey.com/en/products/detail/stmicroelectronics/L6234PD/634708

Thank you very much for your reply, I reallly appreciate, Can you also post how to change or install this particular part. Thank you once again.

 

[Smoke_Jaguar]

Surface mount soldering job there, need someone with special tools who does circuit board repair.

 

[damonCA21]

While smoke jaguar may be correct there is no way knowing exactly what has blown. It could be a resistor, capacitor or the main chip has blown. You need someone to actually check the board and test it, not just assume the motor driver has blown ( it is impossible to tell this just from your description and the error code )