Think713
New Member
Hey everyone,
So far I have not found a particular bit that does this (i have found some for acm bevels for "bending). Our Collet is sized for a 6mm shank. I'm looking for a a bit that I can route 45 degree edges like you would cut with a miter saw.
Now any of you that are familiar with woodworking can probably tell me whether or not thats a good idea, and it might just be better to go ahead and cut the pieces I want on a miter saw. But I do not have one. I guess the biggest issue would be hold down for said material and making sure it doesnt move on the final pass.
That being said if its possible and there is a good bit out there, can you guys point me in the right direction?
So far I have not found a particular bit that does this (i have found some for acm bevels for "bending). Our Collet is sized for a 6mm shank. I'm looking for a a bit that I can route 45 degree edges like you would cut with a miter saw.
Now any of you that are familiar with woodworking can probably tell me whether or not thats a good idea, and it might just be better to go ahead and cut the pieces I want on a miter saw. But I do not have one. I guess the biggest issue would be hold down for said material and making sure it doesnt move on the final pass.
That being said if its possible and there is a good bit out there, can you guys point me in the right direction?