Summa S one d140 fx contour cutting

[msenjur]

im having a troubles with contour cutting with my D140FX.

I use onyx 19, Postershop Cut-Server and Summa cutter control.

the problem is this "large file" (10mb) of 1000 squares shaped and size like stamp. Summa stars cutting, cut one or two segment and then it stops. Often with no message on display. So, now i have a sheet with one third cutted. ok, i turn the sheet around. I starts cutting and it cuts whole sheet. Ofcourse, i stopped it before it get to the part already cutted. Ok, i start with second. It stops somewhere in middle of second segment. Just stops. With no message. I lift rolles and it drops a knife and goes diagonal to origin spot with knife down. Ok, i put that job beside, i dont have nerves to dealt with that. But i will have to solve it this week.

Then i go to my next project. Simple squares (500kb). It cuts first segment, start reading second one, and i get a message to "put tool above missed marker". Marker is right beneath tool. i click check mark on cutter, it reads it, it finds it and i keep getting messages to put tool above marker. wtf. Marker is on one layer gloss vinyl, no lamination, no reflections.....

Where is the problem? I have to solve this problem asap.

 

[balstestrat]

And what if you only use cut server?
There could be a secret Summa patch to Onyx but old version... you might never know.

 

[Snydo]

As for your first problem, I would try running Cutter-Server OR cutter control, not both at the same time.
Is your "missed marker" very close to a dark printed color? If so add a small gutter around the print, and that should solve that problem.

 

[msenjur]

As for your first problem, I would try running Cutter-Server OR cutter control, not both at the same time.
Is your "missed marker" very close to a dark printed color? If so add a small gutter around the print, and that should solve that problem.

hm i dont know why do i have to use postershop cut server... service guy set it up that way.

marker is no close to dark color. it reads well other marks, that are im same position from printed area.

im very confused. i think it is a cutter issue. if i import plt file in cutter-controll, and select only one segment it reads it and cut it. then i select second segment it fails to read, third segment goes ok... and it reads all markers to get to the third segment. so one time it reads same marker and other time it doesnt.

 

[msenjur]

And what if you only use cut server?
There could be a secret Summa patch to Onyx but old version... you might never know.

can i use only cut server?

is there a patch? where can i get it?