• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

WILL VHB tape stick and hold to Brick???

depps74

New Member
I am mounting 1/2" Ultraboard (gator board) prints to a brick wall. The prints are no more than 36" x 24". Will VHB tape hold them to brick or should I use a cleat? I have the 3M VHB clear jelly like tape, 1/2"
 

Moze

Active Member
Short answer, yes - if there's enough surface contact. If it's a rough, uneven brick and the tape is on a bunch of high points without a lot of surface contact, then you would probably have issues.
 

laserfred

New Member
You can also apply two layers of 3M tape on top of each other and you'll get a better contact on highly textured surface. We've had good results on cinder blocks.
 

visual800

Active Member
I would just do dabs of silicone without even wasting vhb tape tape it up painters tape and let it set up
 

kcollinsdesign

Old member
Use a cleat. Easier to install and will be easier to repair later. Plus a cleat allows for easier removing for cleaning or re-positioning.
 

Chris Keena

New Member
You didn't ask me, but just go with RP45. It's about half the cost of most other VHB's and works great.
I had two picked out, the RP45 and VHB 4658 (removable). The RP45 looks like the more reliable to go on poured concrete that was finished/sealed 14 years ago...
 
Top