heyskull
New Member
I use Wasatch 6.2 to print from at the moment and use a Mutoh Valuejet and a Mutoh Ultima to contour cut from.
I am on with upgrading the plotter and am looking at a Graphtec FC-8600 as I have always like Graphtecs plotters and I am getting a real good deal on it.
The issue is that Wasatch6.2 at least my version only supports the CE-5000, FC-5100 or the FC-7000.
The question is can I use one of these to drive the contour cut from Wasatch?
When I speak to Wasatch all they want me to do is upgrade and will not answer the question whether these drivers will run the FC-8600.
I hope I have posted this correctly.
Sorry for the repost but I maybe think this is the correct place to post
SC
I am on with upgrading the plotter and am looking at a Graphtec FC-8600 as I have always like Graphtecs plotters and I am getting a real good deal on it.
The issue is that Wasatch6.2 at least my version only supports the CE-5000, FC-5100 or the FC-7000.
The question is can I use one of these to drive the contour cut from Wasatch?
When I speak to Wasatch all they want me to do is upgrade and will not answer the question whether these drivers will run the FC-8600.
I hope I have posted this correctly.
Sorry for the repost but I maybe think this is the correct place to post
SC