Recent content by Neila Printing

And not printed crooked

Hey I have digital presses can do this job easily

Printing/Installing a larger job that will be up for about 6 months, everyone just seems to be recommending 'house' brands these days. Going to print on the R1000, does anyone have experience with Briteline on the r1000? Any downside? Any other materials anyone recommends which are reasonably...

We do these, message me

Did he mention anything specific

Have you been to the facility?

I have a client that has to repaint walls before we do some vinyl lettering/wall wraps for them. I know some of the newer / low voc paints dont take vinyl well. Does anyone have recommendations on best paints to have them use so that the vinyl will stay on permanently?

I have a job that's 500 business card size pieces on 060 styrene, when we were running samples, didn't yet have the full sheets and the small piece I had the vacuum had some issues holding it down to route out the pieces that small. Getting full sheets tomorrow any tricks to keep the small...

Around 65, media has been in house for a few weeks

Having issues running 12oz dss on the r1000, have tried a variety of settings and have calls in to both ultraflex and HP and they're just pointing at each other, no matter the heat settings the material creates. Anyone had luck with it?

Square, ended up imposing it with imposition software but couldn't find any that does inside crops so had to make boxes around all the fronts for cutting. Has to be a better way

Customer sent in 23 files each different front and back going on rigid board on our flatbed. We do double sided work daily but rarely is it totally variable. What's the best way to impose? Using Onyx Thrive which doesn't seem to be too double sided friendly.

I'll probably be there

I didn't

I can hear the fans going but not the hard drive