Search results

I think you might be correct here. I'll run some tests to see the results. Thanks

Hello Everyone, I've been having this same problem with my HP Latex 365. Problem only occurs when I need to print desaturated / black and white images. We get this pinkish tone that's coming from the magenta - this occurs due to the color correction feature in the Flexi software we're using...

I would recommend you get a corner rounder. I have the Lassco CR-60 and it works great. Can cut up to 0.08in think aluminum. On another note: does anyone know of any way to round corners larger than 1.5in? I am looking to round corners at 1.875in, 2.25in and 3in. I prefer to use a press...

More than likely the problem is that the temperature is too high for the material and it’s warping causing you smearing and head strikes. Reduce the temperature to as low as 185F and increase the passes to 16 so that the ink can dry. You can tweak settings as you see fit but keep the temp as low...

Where can I get these - they seem to be out of stock everywhere.

I have a quick question - does anyone know if this can work for the HP365? I'm looking to add some protection for the printer from any voltage spikes or fluctuations Tripp Lite Isobar 4 Outlet 230V Surge Protector

Thanks for this. I’ve been trying to figure out the best settings for each material without deformations, especially with banner and semi-rigid banner for the pull-up banner stands. It has been a bit of a struggle for me so far to find the right balance but I’m continually tweaking. Will post...

Hello Everyone, I purchased the HP365 Latex early 2021 and as a Roland user for years, found the HP a bit challenging to learn, especially when getting the media profiles right. Although you can download many media profiles online, some just don't seem to work right. Perhaps the temperature is...

This error plagued me through a very lengthy job and caused me to have many failed prints before I could figure the issue out. For me, because I was using a laptop without an ethernet port, and was using an ethernet to USB-C adapter, that connector was the issue. It was too slow, so I upgraded...

-Perhaps it's the banner material - some cheaper materials can't handle the heat and will bunch up and cause head strikes. Turn down the heat as low as you can while still allowing for proper drying of the ink. -It can also be the vacuum pressure is too high. I know some may say to turn it up -...

I've experienced problems with the OMAS sensor on my HP 365. I believe it's mostly a media issue for me - Reflective or cheap banner. Try calibrating again or advancing substrate to calibrate at a different area of the substrate.

Anyone wanting to decide whether to go HP or Roland should take this post into consideration. Great breakdown.

I've been able to use 6p 100% for banner with no noticeable difference from 8p-10p 100%. All you have to do is increase the temperature to about 220F. Anyone else care to share their settings including temp. without media distortion/warp?

I got this same problem so I tried the flattening the image and it worked. Thanks

Seal 54 base laminator troubleshooting seal 54 base laminator doesn't move in snail mode or regular forward or backward - check blown fuse and replace

Fix for this 0080 Troubleshooting this my tech said it could be three causes 1. slack carriage belt 2. bad motor 3. bad servo board youll have to get the service manual for the sp540i or whatever version you own to know how to check these since you'll have to open the machine. You...

I have the same problem with the scan motor error - it sometimes comes up as 0080 or 0010. This happens even when I try to do a test print for print crop calib. I tried getting into service mode but am getting the message "SERVICE MODE PROTECTED" - I don't know if anyone knows how to get...