Search results

when I get to my office I will do some reading. not sure what isn't happening.when you move a machine lots of things can get bounced. I will try to post later

what happens when you leave motor connected electrically but not bolted in? turn machine on, does motor turn, "step" or "pulse"?

i have lots of gerber edge and plotter experience but only seen pictures of a saber if my suggestions don't steer you in the right direction, call "the plotter doctor" in california. jim knows everything

i think you should follow the normal gerber evaluation routine we always use blow out with compressed air reseat all the plugs and connectors (if you want to scrub the circuit boards with alcohol and perhaps resolder all the HEAVIER jack connectors on circuit boards look for "ringed" solder...

i ordered a couple of these thank you for your suggestions with a 6 ft input and exit conveyor would you think i would need 2 or 4? i assume i also need on the exit side

i will look into it in the meantime i ordered a couple of then units firesprint recommended BK5600S

only reason i mention the rip, in flexi, when i specify a cut sheet rigid substrate size, the mutoh will print to within 2 inches of the edge if i am set for ROLL it seems to stop with about 16" to go it also drastically changes the start point and origin (where the leading edge "settles" when...

ok. so no option to print "cut sheet"

if you are that close to end of roll, and need to go right to the end, can’t you tell the rip you are printing on a sheet? if I need to use up something to end of roll I tell the rip on the Mutoh 38 inch print on 40 inch sheet for example. It print to 2 inches from the end

i have the bar and tinsel but got side tracked and never installed it it is actually to the side near my mutoh i had forgotten all about it. i got as far as grounding the in and out conveyors and that was when my wife ended up in the hospital (18 months ago) i will finish installing all of that...

Gg any repair like this (like almost everything in real life) is done at your own risk) whichever of you people who has never f**ked up a machine in the process of trying to fix it should get a medal.

i am reaching the point that i am printing a little bit, again, after all the wife's medical problems the mutoh still gives me intermittent overspray that i blame on static electricity, IN SPITE of the fact that i mist all substrates with isopropyl, wipe dry with microfibre cloth, flip, repeat...

Sometimes grimco annoys me But they have 8 locations in Canada

I buy all my heads from solventinkjet. pricing is good.HEADS ALWAYS ARRIVE ON TIME (you don’t realize how important that is UNTIL IT DOESN’T ARRIVE) great tech support as well!

exactly if they are WET leave them in direct sun for 1-2 days OR in the warehouse under a hanging heater

probably Best to go to eBay, see who is parting out a similar mimaki. look for a power seller with multi0le listings. choose a listing, use contacts/ask seller a question. post a picture in the message do a couple of sellers CAUTION if you don’t frame it as a request to have the gear...

Great for an additional workstation

Jim Hancock will his printer run on versaworks 4? if I go to the office I will see if I have any versaworks 5. can anyone else provide a disk?

JUST A GUESS, but the firmware writes to an eprom some types are erasable & some are WORM (write once read many) unless someone is much better versed than i am, i would approach with caution.

Some of the refurbishers leave the windows installation in an odd state. I blame convoluted and confusing Microsoft rules for those odd licenses forcrefurbishers remember they did NOT allow processor I’d to be stored (so you retained your license until windows 10