Search results

It's warmer out these days...check curing temp before vacuum...less 5 degree intervals until media settles...if the vacuum was fine last week..it should be fine today...

Table height too high/laminator too low? Just build a platform for the laminator or...cut down and re-use the pallet that was used for shipping. your laminator(if you have the space) never has to be moved...

Thanks for the input...

I'm curious what "long run consistency" is supposed to do...the printer uses thermal heads that are not designed for long runs at all...I have never had any issues running in 2.5-3 hour bursts and letting the printer sit for 10 minutes before starting next run...HP said the runs can be longer...

Switched to their vehicle wrap solutions two months ago...less expensive than Avery and 3M and performs really well...they make a basic everyday vinyl that is inexpensive...the liner is thin and takes a little getting used to when working with it but after a few uses its no longer an issue...the...

Is there an industry name for cut vinyl or printed graphics applied to a storefront window or door containing business hours/days of week etc?

That is correct...360 not going anywhere

Might be a key or permissions issue...

I have no issues from my mac...nor my windows 10pc... Once pluging loads send to cutting master

Power off printer unplug remove all consumables unseat all ink cartridges leave media lever up and hood open power back on and have printer ask for all consumables and install 1x1...this does a soft reboot of all boards...might get you past issue... if not contacts are a replaceable part...

The 550 is a gret flatbed...I have first hand experience with it. I would not say this it does anything great...it does however do a lot of things really well. There are FLATBEDS that offer a higher resolution...but the 550is just user friendly. I have used the Oce which is a Fuji flatbed...

The Roland is not for a production environment...more niche...6" nip allows all sorts of substrates to be used...it's not fast...some have complained of excessive verticle banding... there are some other options available as far a hybrids are concerned...

There are orange pads on left and right side of carriage at rail...make sure they are oiled...actually the right side should have an oiler...make sure the reservoir is full. if the bushings on the carriage are shot...they may make replacement parts... if the rail has been compromised it's an...

On belt tensioner...wind both screws in to make silver late flush with bracket...I would not cut belt if you don't have to...

The best bang for the buck is still a latex printer...ink cost/sq' includes all consumables, ink PRINTHEADS and cleaning cartridges...there is no daily maintence..no waste ink to deal with...PRINTHEADS are a consumable lasting 4-5 ink cartridges ea...they off-gas immediately... and if you are...

Re:hp recomending switch...its easier for them to troubleshoot over the phone...a monkey can troubleshoot a switch...power off power on...green means go...

Use the eraser..

I don't believe the s80 supports double sided printing...HP latex 300 series is the only one that I know of...

Make sure you prime the filters on the end of the ink boxes before installing. If you are still having an issue, open box and make sure that the like is not kinked or bent. if vacuum errors...get 2 hemostat clamps...remove service station cover, remove carriage cover. clamp air tube(clear)...

Power off unplug 220...remove cover and reseat cables at both the display and the EBOX...are the EBOX filters clean? One in front one under belt near power plugs... why are you turning the printer off? There is no reason to...if loaded with white ink, I would never turn off...the printer will...