Search results

Thank you!!! Pffff... Someone else?? Spud Murphy can you name the ink you are using?? Thanks, mate!

Check out the F2 fuse on the main board. If there are no nozzles on the test print, that's the cause for sure. It;s a small ceramic fuse 3,15 mA value. You can put another one there instead of that with a similar value (not too big - arround 4mA) and this should do the trick. Regards

Clogged cyan print-heads...:banghead:

Hard to get there :)).

Hi, Yes, I order every time from those guys. If they receive the money today, you will have the order tomorrow - 24 hours delivery. Romania salutes Bulgaria :peace!: You're welcome!:smile:

Hello ranger!!:smile: Welcome to:signs101:

Give me your e-mail address and I'll send you the service manual for ValueJet 1204 with all the instructions.

Hello all! I didn't knew where to put this thread but I guess this is the right place considering the fact that this forum is the most visited. So...I really want to hear your opinion regarding the Cyan ink, no matter the producer. It's just in my head, or, the Cyan ink has something "naughty"...

Not one nozzle?? Have you put them back correctly? If something goes wrong you might fry a fuse or something.

What do you want to repair? There is nothing to be repaired. If everything is fine now, then you are able to feed you print-heads with ink. Pull the ink in the print-head using a syringe. If the capping station is messed up, then you can call a technician to replace that for you or you can...

I don't think has anything to do it it...

It's very possible that the capping station not closing the print head and this way, there is no continuity in your system. Try to clean your capping station very well, and then try again with the syringe.

Randya si right. It's a typical bad head or maybe head cable. Check the head cable first. http://www.digiprint-supplies.com/Valuejet---Epson-Head-Data-Cable---DF-49017-p18130.html http://www.digiprint-supplies.com/Epson-DX5-Valuejet-solvent-print-head-p11623.html

PM your e-mail address. XC manual or SJ manual?

Just try to pull more ink..see if that helps. If not, then a technician is required to replace the print-head.

Any improvement after powerful cleaning? It's the same problem all the time? Did you had a head strike? Take a cleaning stick with cleaning liquid on it and gently touch the print-head surface(not rub but easily press). Try also to take the cap-top out from the pump line(there is a joint...

Hi, I would be much better if you would leave a "belly" to the material, in the back of the printer. If the printer pulls the material directly from the roll, then the roll, being heavy, will oppose resistance and the banding caused by the feed calibration will be obvious. If you take out some...

Have you tried to replace the damper? Maybe you have a air leak between the manifold and the o-ring. Just a thought....

Those printers were conceived to print with water-based inks(sublimation), but you can convert it to eco-sol inks. You will have to replace some parts.

I'm not sure if there is any company selling that part only. It is a part from a bigger assembly (maintenance assy). Good luck with that.