Search results

sorry guys - I had to bump this up so Compilla might remember to look at the pics he requested. Thanks!

Dtio. There is alot of bad money out there! I have learned well...the hard way, of course.,

Nice job! A major undertaking to say the least

I used my equipmet to print personalized labels to put on the gifts unfortunately, I can't afford me to make gifts (too busy) but one day I will!

knew sosmeone who did this - had a pic of the wacky weed and type under it saying "Go Green"

nice

I like! I did alot of cut monogramming and names for folks who applied to laptops This is soooo cool what you hjave done

aaahh she has no clothes on!! And here she is without any clothes on! I've been running jobs like this! - I know, not smart but Im at the "I don't give a sh** any more" stage !

Nozzle Check Here it is. Threw in a pic of the dampers as well Your basic nozzle check w/out a block of cyan!

Light yes - angle of the light, whatever type, is important. White being the hardest, a trick I learned years ago (but no longer use) is pounce chalk rubbed over the unweeded vinyl. Makes the cut lines show up.

Yes. It will be a while - daughter, who is out to lunch, has camera in her car. There is just a blank space in the nozzle check where the second block of cyan should be. KKC_YYMM from Right to left.

Have replaced this connector. There was NO CHANGE - #4 Channel still missing. Swapped Dampers (#3 and #4 with lines intact - which would tell me if the #4damper was bad, I guess) Still missing #4 channel on nozzle check. I never did swap the ribbon cables to see if this was the problem. Does...

Yea - thanks - 'tis done Now, I just hope it doesn't GIVE me the virus! This is my luck lately

sorry to get off the subject but I wondered the same!! UK fans here too - living in Alabama. Daughter now goes to Univ of Alabama so now we get to say "Go Cats" and "Roll Tide"

079 error Oh dear. I have had this before. I installed a New Main Board (did not fix) so we put old one back in There were lots of other (unnecessary) things done: Maint station, head etc, etc, that cost me alot of money by a tech (company that I will not name - still spitting nails...)...

monitor calibration maybe?

have replaced maintenance station dampers print head snipped ink lines and re-attached o-rings syphened ink from under Maint. Stat. at damper connection I feel so defeated

Update New tech - new solution! Our best guess at this point... the Y-connector that is the splitter from main ink line to the two cyan ink lines leading to the heads. I have the part ordered and I'll let you know!

The lines have been put back to the original places - nozzle check now misses the #4 again.

swapped lines and the o-rings that were with those lines. I think I will replace all the o-rings. Yes?