Search results

Glad you brought this up. I’ve been using a decade+ old set of Prismacolor fine and chisel tip markers. I’ve never much needed the fine tip... and honestly, most are all dry now. I’m in the market too for a useful set. Of course I fix small imperfections on prints but they’re used a lot for edge...

Just curious... with the -20F winter, do you think the extreme weather conditions had anything to do with it?

Here is a list of HP’s Laminate recommendations for Latex Prints. It’s from this site: https://hp.globalbmg.com/en/laminationcomp#latex

I always try to be helpful. You never know when they’ll need you for something you CAN do...Give them this: https://www.image360.com/services/sign-installation

To be confident, use epoxy.

A good amount of magnet material was left fused to the doors of a jeep after physically prying and peeling off the magnets.

I've seen magnets left on cars so long that they fuse solid! Unfortunately, no solvent melts magnet off paint. LOL

https://www.stickergenius.com/shop/aluminum-truck-body-reusable-stickers/ Keep it in a drawer, or a rigid portfolio. Use the sticker board (or coroplast). Some things in life just need to stay clean.

https://www.stickergenius.com/shop/aluminum-truck-body-reusable-stickers/

Some research shows that printheads begin to fail and don’t fire at full capacity. Grays are affected most by the light ink printheads. Might be time to change them. Or, ink from a different source can change color.

Will they actually take a tape measure to it? I cannot believe the client is that concerned over 2”. Quote them the cost of the 100ct minimum order and watch them change their minds about the importance the 1” on each side.

Don’t suppose they want 100 signs, eh?

Ultraboard Classic boasts custom cut and custom run sizes. I’d just ask them!https://ultraboard.com/elements/pages/contact/

https://help.cadlink.com/website/signlab_vpm/en/getting_started/media_configuration/fonts_and_clipart.htm

My two cents.. that the font should flow with the “S” and you need to utilize the upper arch area. Looks too heavy at the bottom.

Just a thought, if you’re applying the text also, it’s often easier to weed out the inside after applying.

Blahaus.

Closest I can come is Machiarge or Ravel with modifications.

It’s very close to Bea. But tracing would be the closest! http://www.identifont.com/similar?PC0

Closest I can come is to a modified Atorak... Or Buried Before. Just search for creepy-ass fonts.