Search results

calculate the years running costs add the amount cash you want to make a year devide by the amount days you want to work a year devide that by 6 and you have your houerly rate add on material costs + say 40% and bingo, thats the base cost of the job cost

put the heat on 75 feed rate lowest setting dont over pinch the rollers remaing silvering will be gon by the next day

looks like you have had a lot of head strikes only way is to repace the hole head

hi best way to stop the edges getting ragged is to use a revers spiral singel flute cutter, this pushes swarf down and away unlike a normal cutter that pulls the swarf up and under the laminate slow the cutter RPM down as much as you can, and adjust the feed rate also do a lead in and lead out...

bad spelling sorry

iff your print test is ok try looking at the two outside pinch rollers if thay are flat replace them as the media is starting to slip as a test rotat the image and reprit if the gosting is in the same place i would be looking at the head alignment

no its the way you are fitting it practice makes perfect

try printing in unidirctional or try plaing with the color curves to increse or decreas the ink saturation also Versa works 6 is out now to download

worth a look is the yellow and black head connected to the same cleaning pump? if yes make shore both tubes are the same length if the black cartridge is full and the yellow is quarter full for example, you can get a siphoning effect where the black ink preshour pushes up into the yellow...

put the cleaning flush cartrage in take the damper off the head and pull the flush into the damper with a syringe put back on the head and do a clean to flush out the old ink when you get the new ink just repet the prosess

HI Had this on our old 540 are you still using the small dampers about 1" tall? if not you need to swap them for the hi capacity ones in addition try slowing down the feed rate and turn down the heaters also turn on auto clean and set for about 6m if you still have problems set to unidirectional

Versaworks 6 is out now, free download from roland DG still need to set EPS border to 1mm

i get my parts from https://www.digiprint-supplies.com/en/?gclid=EAIaIQobChMIyNyv1oDI3gIVxITVCh1lEA3qEAAYASAAEgIHuvD_BwE

Pantone colour Bridge is the one you need as it has all the CMYK and PMS colour and values side by side roland profiles will be set for roland inks so i sujest sticking with muto icc profiels for your printer you can allways try downloading the roland versaworks rip and loading in your Muto...

hi thanks will give it a go do you have a icc profile you can send me as a starting point?

hi what rip are you running? have you printed out the rip colour pallet always a good starting point. try picking a red from the colour replacement section within the rip and assign it to the job

we had this problem a lot it may be the data cabel or the top of the head has cracked just under the damper normaly a damaged head cap cased by the dampers rattaling around, easy fix so are the ink lines and dampers full? if yes swap the data cabels yellow to magenta , magenta to yellow ( if...

HI We had the same problem best fix is to undo the arm on the motor side and cut the side off , See photo, put back together this stops the media geting snaged loosen of bottom brackit both sides and make shore all is square to the machine legs and re fit in place. make shore the take up roll...

the most reliabel stuff is made by Almi Grahics no heat requierd :) https://www.alumigraphics.com/

hi try droping your images into this font finder https://www.fontsquirrel.com/matcherator