Search results

HI We stll have over 100 fonts 2x fast boards 2x digitaizing tablets 2x apple design stations x2 4b cutters x2 base units that use to power the system 48 CNC cost around £360,000.00 bak in the 80;s make me an offer we cant refuse the old scanner and wize PC may still be knockiing about

http://support.rolanddga.com/Docs/Documents/departments/Technical%20Services/Manuals%20and%20Guides/SP-300V_USE_EN_R4.pdf

looks like you are printing on banner try turning the pre feed function on also do the enviromental cheque

tap set...

captive studs a good for the back of letters fast and easy to fit, we no risk to the letter, see photo

Back in the late 80s we had a lot of problem with kids steeling the “E” of signs to go raving with.. We tend only to use the push fit internally, All the external Perspex letters have brass or nickel finish threaded locators If we have to use a threaded stud we cut 20mm radius disks out of...

why do you want to tap perspex? you can buy pins on plates that just glue to the rear of the letters or just use locatour fixings

If you have any red led lights on the head board are read you will need a new one If all the led lights are on the board are green Power down the printer take all the heads out Put a small amount of tissue in a flat dish and pour some cleaning flush into the dish just too wet the tissue Put...

hi sounds like static if you cleen the sheet on the printer you will get more static charge in the sheet try cleaning the sheet of the printer and use an anti static solution also when moving the sheet use a anti stactic arm band

0001 Feed Motor Deviation Error Check the carriage motor, and check all the cable. Possible the life of the feed motor is gone 0002 Sub CPU Communication Error Poor communication with Sub CPU "CAUSE: Sub Board does not work correctly Sub CPU does not work correctly. There is a bad...

Hi Replacing the head cap is a very simple process Turn the printer off and unplug it Lower the docking station manually, there is a hole underneath the printer to access the worm screw Remove the print ribbon cabal Remove the spring from the top of the head carriage Take out the 3x screws...

contaminated paper or wrong profile settings

easy fix exprot from corel and inport to signlab

Hi its normally down to ink levels Especially if you are using a bulk ink system or 3rd party inks as they may be more diluted than originals Do the yellow and magenta shear the same pump? If so yellow ink is lower than magenta and the magenta is being pulled into the head via the pump...

1st off if you rub your palm of your hand on the wall and you get paint residue on your hand, you must seal the wal simple:)

Edge lit acrilic is different you need to use a clear LED panel like perspex S-Lux or G-Lux, Plexiglass have there own brand too it as mico beeds that help reflect the light also dont polish the edges mat them down

just use a standerd PVC profile

what error code are you getting?

Start with an environmental check on the printer And then try slowing the feed rate down and reduces the pre-feed heater

hi can recomend the oce we run the arisona 250 gt (fuji is a rebranded oce)