Search results

not even close

hi its not a font best trace / redraw the image, it wont take long mainly line drawing, minimal curves quick tip: try looking for some documentation (PDF) that you can lift the logo off philip

hi Roland are constantly sending out stuff what are you trying to do with the printer?

hi the command is normally in the system menu or sub menu, depending on what firmware you are on if you have the operators book have a look in the appendix if not you can download one from the Roland website or search for the 1: Setup Guide for your printer or 2: Assembly and Ink Filling

the ribbons wont be the problem, but if you must clean them just use a pencil eraser on the contacts, do not let any flush contact them or get into the head , very bad ... when you pull the ink up to the dampener and its filled ok, are the ink lines staying full or are you getting air pockets...

hi if all the colours are present after pulling them into the dampeners, and test print is ok if after printing a short while you are getting full dropout,i would be looking at the head caps as it is very easy to crack the nipple whilst removing & replacing the dampeners if they have any...

hi have you got the latest firmware installed, , is your plotter on the supported device list? FC9000 / CE7000 / FCX4000 / FCX2000 / FC8600* / FC4500* / CE6000* / CE6000 PLUS* / CE LITE-50* The firmware needs to be the following version. • FC9000 series: version 1.28 or later • CE7000 series...

there is an old saying "Ritrama allways a drama" use at your own expence....

hi give nigel a call from planet solutions he has a good knowledge base very helpfully 07989 690072 philip

HI we had the same problem in the rip go to colour management and set it to max density US good luck you may also need to slow the print speed down to give the ink a chance to dry

hi have a look at this web site https://eurobond-adhesives.co.uk/product-category/uv-curing-adhesives/plastic-bonding/ may be something similar your side of the pond

White ink settles in the box very fast, we always give the white a good shake and print about .5m before running the job

For display boxes, we use UV glue as you can put the box together with the glue clean away the excess as you go tape in place, then hit it with the UV light for 5 min, job ready to go

HI Just reading your thread If you haven’t got your printer up and running try this Take the plastic cover off the print head assembly to revel the dampers and print heads Number all the ribbons going into the print heads and number the print heads also Remove the dampers from the...

arizona 250gt

yes but when i go to config printer keeps asking for dill file

Keeps comming up with same message missing arizona dill fille any sugestions

One way to retake possession of the sign is to send them a letter stating that as part of your ongoing Heath and Safety program There sign has been chosen at random to be inspected. tell them to expect representatives to carry out the full inspection on week commencing... normally the client...

HI All Re: Driver problems Has anybody got a OCE Arizona gt250 Prninst file to run in onix 10? Trying to get an old 2008 printer up and running again All help will be appreciated Thanks for looking

Use a polystyrene float with a ply top wrap with banner pvc fix letter rail to ply you will need at lease to ground anchors