Search results

best practice is to reinforce it with Stainless steel U Chanel top and bottom

hi in that case don't get boged down with trying to do cheep boards stand your ground and educate people as to why you only run in hi quality mode with the best pass count the work will come

why don't you use the print merge function built into Corel instead ?

don't over think it you need wide beam angel on the LEDs and stand them off as far as possible, go for a 3000k or 4000k will be softer light than the 6000k and work better with the grey if it was me. I would mount them on a clear perspex back panel with some nice wall supports, make a future...

hi go to: file/install/cutting devices pick any driver and load it once loaded go to: cut/cutting defaults click set up hold down Alt key and press E note pad will open up the ini file open the attached file in notepad edit/select all/copy / paste it into your open ini file / save/...

head strike can nuke the head out of alignment go into service menu and print out the bi directional test prints just the values as requierd Philip

Probably not the answer you are looking for Every print shop has now got into large format printing, all struggling to beet the competition & driving he price down, all running 24-7 only one outcome for them, Doom and Bust. look at the second hand market, its flooded with old UV flatbeds...

do not stand on the letters ether make an new fitting template by hand or with your plotter, place it on a flat workbench place the letters down gently on the paper, be shore to line them up with your level baseline, firmly and evenly push down on the paper, this will leave an impression on the...

HP head office is in Bracknell just off the m4 try calling them 0207 660 3858 good luck

they are your designs, charge for them

HI if you are using illustrator untick use art-board when saving/exporting eps files also add bleed to PDF

HI As Neon gets older it will need moor power as the gas and electrodes decay over time, so you may need a larger power supply take out the switch and connect the power supply directly to a clean power line fridges and such like mess up the modern power supplys if it has an earth protection...

if you are processing EPS files go to file management and set the eps margin to 2mm

why not be professional and survey the site yourself add the survey cost to the final invoice simple

in addition the VG will circulate the ink to stop it clogging this then perform a small clean

hi you can change the cleaning settings in the sub menu turn auto off and set it for ether time spent printing, meterage, or after x amount of prints, most people

hi, we stick direct to the floor and then see the edges with a small amount of resin, once dry flood the lot in one go we tend to do an overlap most of the time but some jobs call for a but joint, over lap then trim both sides and pull away access good luck

Roland TruVis 2 inks (solvent) no lamination required just let it gas off for at least 24hours

we use an aluminium foil based product DRYTAC POLAR STREET FX OUTDOOR ALUMINIUM FLOOR MATERIAL 1200MM

25 Litres