Search results

No. It is the dowside of poor maintenance. Even OEM ink depend on series needs different level of maintenance. Just selecct needed level and all will be good.

Try to recognize what cartridge gives an error. Remove all, go to ink status menu, insert one by one and check what on the display.

It possible main firmware and heater control board firmware are not compatible. Wrong protocol can cause the problem.

Actually, you have to cut edge of plastic pipe. Under old O-ring. And locate new ring on undamaged place. Because the ring made a jam of pipe and air can leak easily on that place.

Normally if the damper is detached from printhead and all pipe connections and damper in good condition ink will not go back. So, it is pipe connections (O-ring) or damper proplem.

Both of them MSA and MEA works perfect for personal range of firmware versions.

Can you explain more detail what do you want to do?

How the FW version knowledge can help?

Try to look into the cartridge holder. You will see a switch with arm on right side. It is InkEnd sensor. Sometimes it can be damaged by a cartidge. Compare with other slots. You can check the state in diagnostic menu or by electric measurement device.

You have to check Ink End sensor in the carhridge holder. It will reset value on the smart card if it activated.

Mistake on the picture. It describes "Top of printhead" But alignment correct for top of dampers. For printhead correct will be opposite top and bottom row. Because the damper has a cross way for ink channel.

The problem may be in not same settings for Program step parameter (same as Resolution). Two values available in settings - 0.01 mm and 0.025 mm. In software should be same as in plotter. Check it.

What kind of pinch rollers? And, you not need to remove springs completely. Just detach one end of spring from movable part of arm. Other side leave at the arm frame.

I have not. Try to use internet search.

Yes. For reset counter you have to put another correct Head rank (maybe from the old printhead). Then counter will be initialized. And, after that, done procedure once again for put actual Head rank.

It is located not in Parameter. It is in root directory, few next after Parameter

On Mutoh Valuejet printers is impossible to downgrade the firmware. For head counter initialization you have to done head replace procedure in diagnostic menu.

E079 Error means no communication between mainboard and heater control board. It may be because heater board firmware not corresponding to mainboard firmware.

If you made a correct plotter selection the conflict is impossible. Software settings overwrites the plotter settings. So, if some parameters did not set in software the paramater for cut takes from the plotter. Actually, I used EasySign software for cut. But Flexi build same principes.

The problem is ink filters in Cyan channels are clogged. So, ink flow not enough for fill all nozzles. What cartridges do you use? It is very often for open refillable cartridges. Because Cyan pigment chemistry not so stable and broken when contact to oxygen in the air.