Search results

It is not the same. I think the way is right. But not so much peoples can do it. I am not sure they wil do it for free.

What tape files?

Decodes - maybe. But it transhfers the data from card to mainboard. And, the mainboard compare brand code in data from card with brand code of mainboard.

No. JFL - firmware file for mainboard. MFL - firmware file for heater board. Your OCE is really Mutoh printer. Other files except Mutoh 1624 firmware you will can not upload to the printer. Because service software analysis printer's serial number and check if it correct firmware for this...

Actually, it is possible to change from OCE wthout any hardware replacements. I saw few units while help for adjusting. Rebranded Mutoh printers (like OCE, Xerox) very cheap on second hand market. Because support is stops. So, most cases it is a tidbit for new small companies with limited...

In my opinion it is not good idea to use USB for print on ValueJet printers. I am not sure, but i think it possible to configure Onyx for print to Windows driver. And, set driver for USB connection.

Try this one. I think it was created for v.7. But it should work on v.11 too https://we.tl/t-LIUvWI97b5

Ink bleedeng can be caused by low temperature of heaters.

The maintenance station is need for get ink flow throught printhead. For refill printhead by ink. It does not use while printing. Pump in maintenace station can make a high pressue for get ink flow. But springs in valves of the dampers may be stronger (case 1). Or may be valves not close...

I think you have the problem because dampers not so good. If nozzle check looks good after cleaning it means maintenance station works properly. Try to install back removed OEM dampers.

What dampers did you use? From Mutoh?

Ink level in refillable cartridges for printer withot subtanks should be less then level of printhead nozzleplate. Other cases you will have ink dripping from the nozzleplate.

Ink level in refillable cartridges for printer without subtanks should be less then level of printhead nozzleplate. Other cases you will have ink dripping from the nozzleplate.

You can install any firmware version on new mainboard

Both printers has a same printhead. But it is not DX7 exactly. Main difference is some annidion features in X model. Like DropMaster feature what compensate media thickness for BiDir adjustment in user media settings.

Minimal margin for edges is 5 mm. It is a printer limitation. It possible to print full width if you will switch off media detection and locate edge of roll to zero print position. Be careful, it is very easy to make your print base and front media guide not so clean.

VJ1324 printer model has a constructive problem. It is blocking valves which located in ink lines between cartridges and printhead. I saw some valve does not worked properly and do not open. So, first of all check the valve on problematic ink line. Temporary (or permanent) solution can be to...

It possibel to use print-server. Many years ago I saw few devices what connected with Dlink DP-301P+ And, Win XP together with Onyx 6 (or 7) or SAI Photoprint 6.

Just make a new stickers from glossy metal tape and black selfadgesive vinyl.

I am sure. It is possible. Maybe not with your ink.